Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1974
SEAL-OUTPUT SHAFT
REMOVAL
1. Remove the propeller shaft (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT/PROPELLER
SHAFT - REMOVAL). Move propeller shaft to the right and tie up.
2. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
3. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove
the flange.
4. Remove the output shaft seal with suitable screw and slide hammer.
INSTALLATION
1. Position the new output shaft seal over the output
shaft and against the transmission case.
2. Use Seal Installer 8902A (1) to install the seal.
3. Verify that the transmission is in PARK in order to
prepare for the installation of the output shaft nut.
4. Install the propeller shaft flange onto the output
shaft and install an new flange nut. Tighten the
flange nut, with a 30 mm 12 point socket, to 200
N·m (147.5 ft.lbs.).
5. Stake the output shaft nut to the output shaft as
follows.Place the Staking Tool 9078 (2) and Driver
Handle C-4171 onto the output shaft.
6. Rotate the Staking Tool 9078 (2) until the alignment
pin (3) engages the output shaft notch (4).
21 - 430
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
LX
7. Press downward on the staking tool until the stak-
ing pin (3) contacts the output shaft nut flange (2).
8. Strike the Driver handle C-4171 with a suitable
hammer until the output shaft nut is securely
staked to the output shaft.
9. Install the propeller shaft (Refer to 3 - DIFFEREN-
TIAL &
DRIVELINE/PROPELLER
SHAFT/PRO-
PELLER SHAFT - INSTALLATION).
LX
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
21 - 431
CABLE-PARK LOCK
REMOVAL
1. Place ignition key in the ACC (2) position.
2. Remove the lower instrument panel trim as neces-
sary to access the park lock cable.
3. Disconnect park lock cable (4) from ignition cylin-
der (3).
21 - 432
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
LX
4. Remove the floor console as necessary for access
to the park lock cable. (Refer to 23 - BODY/INTE-
RIOR/FLOOR CONSOLE - REMOVAL)
5. If necessary, remove the bolts holding the shield,
covering the gearshift and park lock cables, to the
floorpan and remove the shield.
6. Disconnect the park lock cable from the shift mech-
anism.
Release
retention
tab
using
suitable
screwdriver.
INSTALLATION
1. Verify that ignition key is in ACC (2) position.
LX
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
21 - 433
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст