Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1710
BUSHING-REAR CROSSMEMBER FRONT MOUNT
REMOVAL
1. Disconnect and isolate battery negative cable (2)
from battery post.
2. Raise and support vehicle. (Refer to LUBRICATION
&
MAINTENANCE/HOISTING
-
STANDARD
PROCEDURE)
3. On each side of vehicle rear, remove wheel mount-
ing nuts (3), then tire and wheel assembly (1).
13 - 40
FRAME & BUMPERS
LX
4. Remove
rear
exhaust
system
(2)
(dual-outlet
exhaust shown in figure). (Refer to 11 - EXHAUST
SYSTEM - REMOVAL)
5. Apply alignment index marks (3) to the propeller
shaft rubber coupler (1) and axle flange (2).
6. Remove three (four if equipped with 215 MM axle)
propeller shaft coupler-to-axle flange bolts and
nuts.
LX
FRAME & BUMPERS
13 - 41
7. Support propeller shaft (2) using a bungee cord (1).
Attach ends of cord to fuel tank straps as shown.
NOTE: Due to short travel and low spring tension,
it is not necessary to lock-out parking brake lever
to service parking brake components.
8. Disconnect front parking brake cable (5) at connec-
tor (3) to right rear parking brake cable (4) above
axle differential.
13 - 42
FRAME & BUMPERS
LX
9. Remove front parking brake cable (3) from equal-
izer (2).
10. Remove screw (2) fastening front parking brake
cable (1) routing bracket to rear crossmember
front flange (3).
LX
FRAME & BUMPERS
13 - 43
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст