Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 808
•
When Monitored:
With the ignition on.
•
Set Condition:
When the FCM detects a HIGH condition.
Possible Causes
(W1) WASHER FLUID LEVEL SWITCH SENSE SHORT TO VOLTAGE
FRONT CONTROL MODULE
Diagnostic Test
1.
INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all FCM DTC’s.
Turn the Wiper Washers on.
With the Scan Tool, read the Wiper DTC’s.
Does the Scan Tool read: B2328-WASHER FLUID LEVEL SENSOR INPUT CIRCUIT HIGH?
Yes
>> Go To 2
No
>> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible
intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
2.
W1 WASHER FLUID LEVEL SENSOR CONTROL CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the Washer Fluid Level Sensor connector.
Disconnect the Front Control Module C1 connector.
Measure the voltage of the (W1) Washer Fluid Level Sensor control cir-
cuit.
Is the voltage above 10.0 volts?
Yes
>> Repair the (W1) Washer Fluid Level Sensor control circuit.
Perform the BODY VERIFICATION TEST — VER 1. (Refer
to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/
FRONT CONTROL MODULE - DIAGNOSIS AND TEST-
ING)
No
>> Replace the Front Control Module in accordance with the
service information.
Perform the BODY VERIFICATION TEST — VER 1. (Refer
to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/
FRONT CONTROL MODULE - DIAGNOSIS AND TEST-
ING)
8R - 52
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
LX
B210D-BATTERY VOLTAGE LOW (RSM)
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
With the ignition on.
•
Set Condition:
Rain Sensor Module supply voltage less than 8.0 volts.
Possible Causes
VEHICLE CHARGING SYSTEM
RAIN SENSING MODULE
Diagnostic Test
1.
CHECK FOR ACTIVE DTC: B210D-BATTERY VOLTAGE LOW
Turn the ignition on.
With the scan tool, record and erase Rain Sensor Module DTCs.
Wait 30 seconds.
With the scan tool, read Rain Sensor Module DTCs.
Is DTC: B210D-BATTERY VOLTAGE LOW active?
Yes
>> Go To 2
No
>> The condition that caused this code to set is not present at this time. Check for an intermittent condition
by inspecting the related wiring harness for chaffed, pierced, pinched, and partially broken wires. Also
inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated termi-
nals.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
2.
VERIFY OPERATION OF THE VEHICLE CHARGING SYSTEM
NOTE: Troubleshoot any PCM charging/cranking DTCs before proceeding.
NOTE: Ensure the battery is fully charged.
Are any charging system DTCs present?
Yes
>> (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAG-
NOSIS AND TESTING)
No
>> Replace the Rain Sensor Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
LX
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
8R - 53
B210E-BATTERY VOLTAGE HIGH (RSM)
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
With the ignition on.
•
Set Condition:
Rain Sensor Module supply voltage greater than 16.0 volts.
Possible Causes
VEHICLE CHARGING SYSTEM
RAIN SENSOR MODULE
Diagnostic Test
1.
CHECK FOR ACTIVE DTC: B210E-BATTERY VOLTAGE HIGH
Turn the ignition on.
With the scan tool, record and erase Rain Sensor Module DTCs.
Wait 30 seconds.
With the scan tool, read Rain Sensor Module DTCs.
Is DTC: B210E-BATTERY VOLTAGE HIGH active?
Yes
>> Go To 2
No
>> The condition that caused this code to set is not present at this time. Check for an intermittent condition
by inspecting the related wiring harness for chaffed, pierced, pinched, and partially broken wires. Also
inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated termi-
nals.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
2.
VERIFY OPERATION OF THE VEHICLE CHARGING SYSTEM
NOTE: Troubleshoot any PCM charging/cranking DTCs before proceeding.
NOTE: Ensure the battery is fully charged.
Are any charging system DTCs present?
Yes
>> (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAG-
NOSIS AND TESTING)
No
>> Replace the Rain Sensor Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
8R - 54
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
LX
B2211-RAIN SENSOR MODULE INITIALIZATION PERFORMANCE
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
With the ignition on.
•
Set Condition:
This DTC is set when the internal initialization state machine is set to FAIL.
Possible Causes
WINDSHIELD
RAIN SENSOR MODULE
Diagnostic Test
1.
CHECK FOR DELAMINATION ON THE WINDSHIELD
NOTE: If module has been reflashed or powered up while not connected to the windshield, this DTC will set.
If this is the case, reattach the RSM to the windshield and proceed.
Check the contact surface of the Rain Sensor Module to the windshield for delamination (this will resemble air bub-
bles in the contact area).
Is delamination present on the windshield?
Yes
>> Replace the windshield in accordance with the service information
Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
No
>> Go To 2
2.
REPLACE THE RAIN SENSOR MODULE
With the scan tool read RSM DTCs.
Does the scan tool read: B2211-RAIN SENSOR MODULE INITIALIZATION PERFORMANCE?
Yes
>> Replace the RSM in accordance with the service information.
Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
No
>> Test complete.
LX
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
8R - 55
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст