Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 753
3. Remove the rear shelf trim panel (Refer to 23 -
BODY/INTERIOR/REAR SHELF TRIM PANEL -
REMOVAL).
4. Remove the one retaining nut (1) to the center seat
belt retractor (2).
REAR CENTER - WAGON
1. Remove the left seat back trim cover (60% portion
of the rear folding seats) (Refer to 23 - BODY/
SEATS/SEAT
BACK
CUSHION/COVER
-
REMOVAL).
2. Disconnect the rear seat back latching cable from
seat frame.
NOTE: If the seat back is not fully latched, the
center seat belt will not release from the retractor.
3. Remove the one bolt (2) holding the rear center
seat belt retractor.
8O - 418
RESTRAINTS - SERVICE INFORMATION
LX
INSTALLATION
FRONT
1. Position the retractor in the B-pillar (1) with the
indexing tabs (2).
2. Install the one front seat belt retractor (4) retaining
bolt (3). Torque bolt to 32 N·m (24 ft. lbs.).
3. Install the one screw between the upper retractor
indexing tabs (2) in B-pillar.
4. Connect the tensioner (2) squib connector (3).
5. Install the one screw (2) to the front seat belt web
guide (3). Torque screw to 3 N·m (20 in. lbs.).
LX
RESTRAINTS - SERVICE INFORMATION
8O - 419
6. Position the upper turning loop (3) and install the
retaining bolt (4). Torque bolt to 40 N·m (30 ft. lbs.).
7. Install the upper turning loop (3) trim cover (2).
8. Install the lower B-pillar trim (Refer to 23 - BODY/
INTERIOR/B-PILLAR TRIM - INSTALLATION).
9. Position the seat belt (1) onto the stud on the seat
cushion frame and install the lower anchor nut (2).
Torque nut to 37 N·m (27 ft. lbs.).
10. Install the trim cover (3) onto the seat cushion
outboard trim cover.
WARNING: Do not connect the battery negative
cable (Refer to 8 - ELECTRICAL/RESTRAINTS -
DIAGNOSIS AND TESTING - AIRBAG SYSTEM).
Personal injury or death may result if the system
test is not performed first.
8O - 420
RESTRAINTS - SERVICE INFORMATION
LX
REAR - SEDAN
1. Position the retractor (4) on the C-pillar to the
indexing tab slips up into the pillar.
2. Install the retractor mounting bolt (3). Torque bolt to
32 N·m (24 ft. lbs.).
3. Install the one upper turning loop retaining bolt (2).
Torque bolt to 40 N·m (30 ft. lbs.).
4. Install the upper C-pillar trim panel (Refer to 23 -
BODY/INTERIOR/C-PILLAR
TRIM
-
INSTALLATION).
LX
RESTRAINTS - SERVICE INFORMATION
8O - 421
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст