Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 174
5. Support spring link (1) using a transmission jack (5)
or other appropriate jack. Raise spring link just
enough to access brake caliper lower mounting bolt
(4) from above compression link (2).
6. Remove the lower and upper caliper mounting
bolts (1).
7. Remove brake caliper (2) with pads from knuckle
and brake rotor. Hang assembly out of way using
wire or a bungee cord. Use care not to overextend
brake hose when doing this.
8. Remove any clips (3) retaining brake rotor (2) to
wheel mounting studs.
9. Slide brake rotor (2) off hub and bearing (1).
5 - 138
BRAKES - BASE
LX
INSTALLATION
FRONT
NOTE: Inspect brake pads before installation. (Refer to 5 - BRAKES/HYDRAULIC/MECHANICAL/BRAKE
PADS/SHOES - INSPECTION)
1. Clean hub face (1) to remove any dirt or corrosion
where rotor mounts.
2. Install brake rotor (2) over studs on hub and
bearing.
3. AWD – Install disc brake caliper and adapter
assembly (2) over brake rotor.
4. AWD – Install mounting bolts (1) securing caliper
adapter (2) to knuckle (3). Tighten bolts to 95 N·m
(70 ft. lbs.) torque.
LX
BRAKES - BASE
5 - 139
5. RWD – Install disc brake caliper and adapter
assembly (3) over brake rotor.
6. RWD – Install mounting bolts (2) securing caliper
adapter (3) to knuckle (1). Tighten bolts to 95 N·m
(70 ft. lbs.) torque.
7. Install tire and wheel assembly (1) (Refer to 22 -
TIRES/WHEELS - INSTALLATION). Tighten wheel
mounting nuts (3) to 150 N·m (110 ft. lbs.) torque.
8. Lower vehicle.
9. Pump brake pedal several times to ensure vehicle
has a firm brake pedal before moving vehicle.
10. Check and adjust brake fluid level in reservoir (1)
as necessary.
CAUTION: If NEW brake rotors or pads have been
installed, keep in mind that braking effectiveness
might be somewhat reduced during the first brake
applications following installation.
11. Road test vehicle and make several stops to wear
off any foreign material on brakes and to seat
brake shoes.
5 - 140
BRAKES - BASE
LX
REAR
NOTE: Inspect disc brake pads and parking brake shoes before installation. (Refer to 5 - BRAKES/HYDRAU-
LIC/MECHANICAL/BRAKE PADS/SHOES - INSPECTION)
1. Clean hub face to remove any dirt or corrosion
where brake rotor mounts (1).
2. Install brake rotor (3) over wheel mounting studs
and onto hub (1).
3. Install disc brake caliper and adapter assembly (3)
over brake rotor.
4. Install mounting bolts (1) securing caliper adapter
(3) to knuckle (2). Tighten bolts to 115 N·m (85 ft.
lbs.) torque.
LX
BRAKES - BASE
5 - 141
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст