Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2094
1. Clean wheel mounting surfaces, removing any
build-up of corrosion. It is important to have good
metal-to-metal contact between wheel and vehicle.
2. Position tire and wheel assembly (1) on wheel
mounting studs using hub pilot as guide. Place and
hold wheel flush up against mounting surface.
NOTE: Always use the original (OEM) style wheel
mounting (lug) nuts. Do not use replacement parts
of lesser quality or substitute design.
3. Loosely install all five wheel mounting (lug) nuts
(3).
4. Lightly snug all wheel mounting nuts, then progres-
sively tighten them in proper sequence shown.
Tighten nuts to 150 N·m (110 ft. lbs.).
5. If applicable, install wheel center cap (4).
6. Lower vehicle.
22 - 12
TIRES/WHEELS
LX
TIRE AND WHEEL ASSEMBLY (STEEL WHEEL)
WARNING: Installing wheels without good metal-to-metal contact with the mounting surface could cause
loosening of the wheel mounting (lug) nuts. This could adversely affect the safety and handling of the vehi-
cle.
NOTE: Never use oil or grease on studs or wheel mounting nuts.
1. Clean wheel mounting surfaces, removing any cor-
rosion build-up. It is important to have good metal-
to-metal contact between wheel and vehicle.
2. Position tire and wheel assembly (1) on wheel
mounting studs using hub pilot as guide. Place and
hold wheel flush up against mounting surface.
NOTE: Wheel mounting nuts must be installed on
the studs as shown (2) to allow proper installation
of the wheel cover.
3. Using valve stem as an index placed at 12 O’clock
position (1), install and lightly tighten two wheel
mounting nuts on studs located at 2 O’clock and 10
O’clock positions as shown (2).
LX
TIRES/WHEELS
22 - 13
4. Place wheel cover (3) on wheel in the following
fashion:
a. Align valve notch in wheel cover with valve
stem on wheel (2).
b. At same time, align two holes in wheel cover
having retaining tabs (1) with two installed
wheel nuts.
c. Press in on center of wheel cover until wheel
cover retaining tabs (1) push past and engage
rear of previously installed wheel mounting
nuts. This will hold wheel cover in place.
5. Install and lightly tighten three remaining wheel
mounting nuts (3) securing wheel cover in place.
6. Progressively tighten all five wheel mounting nuts
in proper sequence. Tighten wheel nuts to 150 N·m
(110 ft. lbs.) torque.
7. Lower vehicle.
22 - 14
TIRES/WHEELS
LX
SPECIAL TOOLS
TIRES AND WHEELS
Dial Indicator C-3339A
Press, Ball Joint C-4150A
LX
TIRES/WHEELS
22 - 15
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст