Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1532
15. Install the left exhaust manifold. (Refer to 9 -
ENGINE/MANIFOLDS/EXHAUST
MANIFOLD
-
INSTALLATION).
16. Raise the vehicle.
17. Connect the left exhaust pipe (2) and connect the
oxygen sensor (3).
18. Lower the vehicle.
19. Install the left rocker arm assembly.
20. Install the left cylinder head cover and ground
strap.
21. Install lower intake manifold (4) (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
MANIFOLD
-
INSTALLATION).
22. Install the fuel rail (1).
23. Install the upper intake manifold (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
MANIFOLD
-
INSTALLATION).
24. Connect the air cleaner element housing (Refer to
9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER
HOUSING - INSTALLATION).
25. Fill the coolant system.
26. Connect the negative battery cable.
9 - 2152
ENGINE - 3.5L - SERVICE INFORMATION
LX
SEAL -CAMSHAFT OIL
REMOVAL
RIGHT CYLINDER HEAD
1. Disconnect the negative battery cable.
2. Remove front timing cover and align the camshaft gear (1,8) and crankshaft gear timing mark (9) to TDC (Refer
to 9 - ENGINE/VALVE TIMING/TIMING BELT / CHAIN COVER(S) - REMOVAL).
3. Remove timing belt (4).
TIMING GEAR ALIGNMENT
1 - RIGHT CAMSHAFT GEAR ALIGNMENT MARK
7 - LEFT CAMSHAFT GEAR
2 - RIGHT CAMSHAFT GEAR
8 - LEFT CAMSHAFT GEAR ALIGNMENT MARK
3 - CYLINDER HEAD TO INNER TIMING BELT COVER BOLTS -
RIGHT
9 - CRANKSHAFT GEAR ALIGNMENT MARK
4 - TIMING BELT
10 - CRANKSHAFT GEAR
5 - WATER PUMP PULLEY
11 - TIMING BELT TENSIONER PULLEY
6 - CYLINDER HEAD TO INNER TIMING BELT COVER BOLTS -
LEFT
12 - TIMING BELT TENSIONER
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2153
4. Remove the right camshaft sprocket (Refer to 9 -
ENGINE/VALVE
TIMING/TIMING
BELT/CHAIN
AND SPROCKETS - REMOVAL).
5. Remove the EGR valve and camshaft thrust plate
(1) from the rear of the cylinder head.
9 - 2154
ENGINE - 3.5L - SERVICE INFORMATION
LX
6. Remove the cylinder head cover (Refer to 9 -
ENGINE/CYLINDER
HEAD/CYLINDER
HEAD
COVER(S) - REMOVAL).
7. Remove the rocker arm assembly (Refer to 9 -
ENGINE/CYLINDER
HEAD/ROCKER
ARM
/
ADJUSTER ASSY - REMOVAL).
8. Maneuver the camshaft rearward and out of the
cylinder head approximately 3.5 inches.
NOTE: Care must be taken not to damage the cylinder head to seal or camshaft journal surfaces when
removing the camshaft seal.
9. Using an appropriate driver carefully remove cam-
shaft oil seal.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2155
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст