Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 391
INSTALLATION
1. Clean any debris off the mating surfaces of the HCU and ABM.
CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant.
2. If the seals (1) on the solenoid valve stems (2) are
not new, replace them all. Each of the solenoid
valve stem seals must be new to keep out moisture
and debris; do not reuse solenoid valve stem
seals.
3. Replace the pump/motor connector O-ring (1) if it is
not new. Be sure the O-ring is properly seated in
the mounting groove (2).
8E - 254
ELECTRONIC CONTROL MODULES - SERVICE INFORMATION
LX
4. Align components and install the ABM (1) on the
HCU (2).
5. Install the four screws (1) attaching the ABM (2) to
the HCU. Tighten the mounting screws to 2 N·m
(17 in. lbs.).
6. Position ICU (1) above mounting grommets (2)
located in body side rail and press mounting
bracket into place.
LX
ELECTRONIC CONTROL MODULES - SERVICE INFORMATION
8E - 255
7. Clip rear brake tubes (1, 2) to routing clip (3) on
bracket below Fuse And Relay Center.
8. Clip right front brake tube (3) to routing clip on
bracket below Fuse And Relay Center.
9. Clip brake tubes to two routing clips (1) along
upper radiator support.
CAUTION: Before installing the ABM harness con-
nector (2) on the ABM (1), be sure the seal is prop-
erly installed in the connector.
10. Insert ABM harness connector (2) into socket of
ABM (1) and close cover, locking connector in
place.
8E - 256
ELECTRONIC CONTROL MODULES - SERVICE INFORMATION
LX
11. Connect battery negative cable (2) to battery post.
It is important that this is performed properly.
(Refer to 8 - ELECTRICAL/BATTERY SYSTEM -
STANDARD PROCEDURE)
12. Perform Diagnostic Verification Test and clear any
faults. (Refer to 5 - BRAKES - DIAGNOSIS AND
TESTING)
LX
ELECTRONIC CONTROL MODULES - SERVICE INFORMATION
8E - 257
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст