Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1634
DAMPER-CRANKSHAFT
REMOVAL
1. Disconnect negative cable from battery.
2. Remove accessory drive belt (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL).
3. Drain cooling system (Refer to 7 - COOLING - STANDARD PROCEDURE).
4. Remove radiator upper hose.
5. Remove fan shroud (Refer to 7 - COOLING/ENGINE/RADIATOR FAN - REMOVAL).
6. Remove crankshaft damper bolt.
7. Remove damper using Special Tools 8513A Insert
and 1023 Three Jaw Puller.
INSTALLATION
CAUTION: To prevent severe damage to the Crank-
shaft, Damper or Special Tool 8512–A, thoroughly
clean the damper bore and the crankshaft nose
before installing Damper.
1. Slide damper onto crankshaft slightly.
CAUTION: Special Tool 8512–A, is assembled in a
specific sequence. Failure to assemble this tool in
this sequence can result in tool failure and severe
damage to either the tool or the crankshaft.
2. Assemble Special Tool 8512–A as follows, The nut
is threaded onto the shaft first (2). Then the roller
bearing (1) is placed onto the threaded rod (3) The
hardened bearing surface of the bearing (1) MUST
face the nut (2). Then the hardened washer (5)
slides onto the threaded rod (3). Once assembled coat the threaded rod’s threads with Mopar
T
Nickel Anti-Seize
or (Loctite No. 771).
3. Using Special Tool 8512–A, press damper onto crankshaft.
4. Install then tighten crankshaft damper bolt to 176 N·m (129 ft. lbs.).
5. Install radiator upper hose.
9 - 2560
ENGINE - 6.1L SERVICE INFORMATION
LX
6. Install accessory drive belt (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION).
7. Refill cooling system (Refer to 7 - COOLING - STANDARD PROCEDURE).
8. Connect negative cable to battery.
LX
ENGINE - 6.1L SERVICE INFORMATION
9 - 2561
COVER-STRUCTURAL
DESCRIPTION
The structural dust cover is made of die cast aluminum and joins the lower half of the transmission bell housing to
the engine. The LX uses an integral one piece aluminum oil pan/structural cover.
OPERATION
The structural cover provides additional powertrain stiffness and reduces noise and vibration. The LX uses an inte-
gral structural cover/oil pan.
9 - 2562
ENGINE - 6.1L SERVICE INFORMATION
LX
ENGINE MOUNTING-FRONT
REMOVAL
1. Disconnect negative battery cable.
2. Raise vehicle.
3. Remove the generator support bracket (1).
LX
ENGINE - 6.1L SERVICE INFORMATION
9 - 2563
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст