Chrysler New Yorker. Manual — part 406

TEST 7A

CHIME INOPERATIVE WITH VEHICLE SPEED ABOVE 75 MPH (120 KMH) (GULF
COAST COUNTRIES ONLY)

Perform TEST 1A Before Proceeding

NOTES

C
H

I

M

E

S
Y
S

T

E

M

222

TEST 7A

CHIME INOPERATIVE WITH VEHICLE SPEED ABOVE 75 MPH (120 KMH) (GULF
COAST COUNTRIES ONLY)

Perform TEST 1A Before Proceeding

*Perform Verification TEST VER-2A.

**Check connectors - Clean / repair as necessary.

NOTE: THIS SYMPTOM

APPLIES TO GULF

START TEST 7A.

COAST COUNTRIES

ONLY.

USING THE DRB,

IS A GULF COAST

SELECT A GULF

TURN THE IGNITION

ENSURE THE CORRECT

COUNTRY CODE

NO

COAST COUNTRY CODE

ON.

COUNTRY CODE HAS

SELECTED FOR THE

FOR THE BODY

BEEN SELECTED FOR

BCM?

CONTROL MODULE.

THE BCM.

YES

USING THE DRB,

REFER TO THE

CHECK THE PCM FOR

ARE ANY VEHICLE

YES

POWERTRAIN

ANY VEHCILE SPEED

SPEED SENSOR CODES

DIAGNOSTIC MANUAL

SENSOR CODES.

PRESENT?

FOR THE

APPROIATE TEST.

NO

WITH THE DRB ENTER

"BODY COMPUTER"

DID THE CHIME

NO REPLACE THE BODY

THEN "ACTUATOR

SOUND?

CONTROL MODULE.*

TESTS" AND ACTUATE

THE CHIME.

YES

THE CHIME IS

OPERATIONAL WITH

NO PROBLEMS FOUND.

C
H

I

M

E

S
Y
S

T

E

M

223

TEST 8A

REPAIRING CHIME SOUNDS WITH DRIVER SEAT BELT FASTENED

Perform TEST 1A Before Proceeding

FIG. 1

C
H

I

M

E

S
Y
S

T

E

M

224

TEST 8A

REPAIRING CHIME SOUNDS WITH DRIVER SEAT BELT FASTENED

Perform TEST 1A Before Proceeding

*Perform Verification TEST VER-2A.

**Check connectors - Clean / repair as necessary.

NOTE: FOR LOCATION
OF ALL COMPONENTS.

TURN THE IGNITION

START TEST 8A.

OFF.

SEE GENERAL INFO 4.0

NOTE: MAKE SURE

TURN THE IGNITION

DID THE CHIME

NO

THE CHIME IS

THE DRIVER SEAT

ON.

SOUND?

OPERATIONAL WITH

BELT IS FASTENED.

NO TROUBLE FOUND.

YES

DOES THE DRB

WITH THE DRB, READ

DISPLAY

NO

REPLACE THE BODY

THE SEAT BELT

"SEAT BELT SWITCH:

CONTROL MODULE.*

SWITCH STATUS.

CLOSED"?

YES

DISCONNECT THE

DOES THE DRB

SEAT BELT SWITCH

WITH THE DRB, READ

DISPLAY

NO

REPLACE THE SEAT

HARNESS

THE SEAT BELT

"SEAT BELT SWITCH:

BELT SWITCH.*

CONNECTOR.** SWITCH

STATUS.

CLOSED"?

YES

KEY OFF.

WITH AN OHMMETER,

DISCONNECT THE

MEASURE BETWEEN

IS THE RESISTANCE

NO

REPLACE THE BODY

BODY CONTROL

GROUND AND THE SEAT

BELOW 5.0 OHMS?

CONTROL MODULE.*

MODULE C4 HARNESS

BELT SWITCH SENSE

CONNECTOR.**

CIRCUIT. FIG. 1

YES

REPAIR THE SEAT

BELT SWITCH SENSE

CIRCUIT FOR A

SHORT TO GROUND.*

C
H

I

M

E

S
Y
S

T

E

M

225