Chrysler New Yorker. Manual — part 373
TEST 18A
REPAIRING STORED TROUBLE CODES
Perform TEST 1A Before Proceeding
A
I
R
B
A
G
S
Y
S
T
E
M
90
TEST 18A
REPAIRING STORED TROUBLE CODES
Perform TEST 1A Before Proceeding
1. Wiggle the wiring harness and connectors of the airbag system, and rotate the steering wheel
from stop to stop. Check for trouble codes as you work through the system. Refer to General
Information Section 4.0 for system component location and connector pinouts.
2. If a stored trouble code becomes active, perform TEST 1A.
3. If a stored code is reproducible:
- Repair or replace the wiring harness
- Repair or replace the harness connector or terminals
- Replace the component as necessary
Refer to the specific diagnostic tests for trouble code set parameters and possible causes.
A
I
R
B
A
G
S
Y
S
T
E
M
91
TEST 19A
AIRBAG CONTROL MODULE REPLACEMENT PROCEDURE
Perform TEST 1A Before Proceeding
A
I
R
B
A
G
S
Y
S
T
E
M
92
TEST 19A
AIRBAG CONTROL MODULE REPLACEMENT PROCEDURE
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-1A.
**Check connectors - Clean / repair as necessary.
WARNING: MAKE SURE
THE BATTERY IS
START TEST 19A.
DISCONNECTED AND
WAIT 2 MINUTES
BEFORE PROCEEDING.
WARNING: IF THE
REFER TO SECTION
AIRBAG CONTROL
"8M" OF THE
FOR REPLACEMENT OF
REPLACE THE AIRBAG
MODULE IS DROPPED
APPROPRIATE
THE AIRBAG CONTROL
CONTROL MODULE
AT ANY TIME,IT
SERVICE MANUAL...
MODULE.
(ACM).*
MUST BE REPLACED.
A
I
R
B
A
G
S
Y
S
T
E
M
93
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст