Chrysler Town, Dodge Caravan. Manual — part 675
SKIS VERIFICATION
APPLICABILITY
1. Reconnect all previously disconnected components and connectors.
2. Obtain the vehicle’s unique Personal Identification Number (PIN) assigned to it’s original
SKIM. This number can be obtained from the vehicle’s invoice or Chrysler’s Customer Center
(1-800-992-1997).
3. NOTE: When entering the PIN, care should be taken because the SKIM will only
allow 3 consecutive attempts to enter the correct PIN. If 3 consecutive incorrect PINs
are entered, the SKIM will Lock Out the DRBIII
t for 1 hour.
4. To exit Lock Out mode, the ignition key must remain in the Run position continually for 1
hour. Turn off all accessories and connect a battery charger if necessary.
5. With the DRBIII
t, select Theft Alarm, SKIM and Miscellaneous. Then, select the desired
procedure and follow the steps that will be displayed.
6. If the SKIM has been replaced, ensure all of the vehicle ignition keys are programmed to the
new SKIM.
7. NOTE: Prior to returning vehicle to the customer, perform a module scan to be sure
that all DTCs are erased. Erase any DTCs that are found.
8. With the DRBIII
t, erase all DTCs. Perform 5 ignition key cycles leaving the key on for at
least 90 seconds per cycle.
9. With the DRBIII
t, read the SKIM DTCs.
Are there any SKIM DTCs?
All
Yes
→ Repair is not complete, refer to appropriate symptom.
No
→ Repair is complete.
508
VERIFICATION TESTS
Verification Tests —
Continued
8.0
COMPONENT LOCATIONS
8.1
CONTROL MODULES AND FUSE & RELAY CENTER
2.4L
3.3L/3.8L
8.2
CONTROLS AND SOLENOID
3.3L/3.8L
C
O
M
P
O
N
E
N
T
L
O
C
A
T
I
O
N
S
509
COMPONENT LOCATIONS
2.4L
3.3L/3.8L
2.4L
3.3L/3.8L
2.4L
3.3L/3.8L
C
O
M
P
O
N
E
N
T
L
O
C
A
T
I
O
N
S
510
COMPONENT LOCATIONS
8.2
CONTROLS AND SOLENOID (Continued)
2.4L
3.3L/3.8L
8.3
DATA LINK CONNECTOR
C
O
M
P
O
N
E
N
T
L
O
C
A
T
I
O
N
S
511
COMPONENT LOCATIONS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст