Chrysler Crossfire. Manual — part 692
4. Remove the lower air cleaner housing. (Refer to 9 -
ENGINE/AIR
INTAKE
SYSTEM/AIR
CLEANER
HOUSING - REMOVAL).
5. Remove the right and left intake plenums. (Refer to
9 - ENGINE/MANIFOLDS/INTAKE MANIFOLD -
REMOVAL).
ZH
FUEL INJECTION
14 - 49
6. Remove the throttle body. (Refer to 14 - FUEL
SYSTEM/FUEL INJECTION/THROTTLE BODY -
REMOVAL).
7. Remove the supercharger outlet housing (2) by
removing the supercharger outlet housing hose
clamps.
8. Disconnect the MAP sensor (1) harness connector.
9. Remove the MAP sensor mounting bolts.
10. Remove the MAP sensor (1).
14 - 50
FUEL INJECTION
ZH
INSTALLATION
INSTALLATION
1. Install the MAP sensor.
2. Install the bolt (1).
3. Connect the Manifold Absolute Pressure (MAP)
harness connector.
4. Install the engine cover. Align the engine cover
retaining clips to the rubber mounts, and push
down firmly to connect engine cover to rubber
mounts.
Note: To ease the installation of the engine cover,
apply a small amount of lubricant to the engine
cover rubber mounts.
5. Connect the negative battery cable.
INSTALLATION - SRT
1. Install the MAP sensor (1).
2. Install the MAP sensor mounting bolts. Tighten to
4.5 N·m (40 in. lbs.).
3. Connect the MAP sensor (1) harness connector.
4. Install the supercharger outlet housing (2). Tighten
the supercharger outlet housing hose clamps.
ZH
FUEL INJECTION
14 - 51
5. Install the throttle body. (Refer to 14 - FUEL SYS-
TEM/FUEL
INJECTION/THROTTLE
BODY
-
INSTALLATION).
6. Install both right and left intake plenums. (Refer to
9 - ENGINE/MANIFOLDS/INTAKE MANIFOLD -
INSTALLATION).
14 - 52
FUEL INJECTION
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст