Chrysler Crossfire. Manual — part 663
4. Remove the lower oil pan retaining bolts and the
lower oil pan (1).
REMOVAL - UPPER OIL PAN
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove the lower splash shield screws (1) and the
splash shield (2).
4. Remove the lower oil pan (Refer to 9 - ENGINE/LUBRICATION/OIL PAN - REMOVAL).
5. Remove the front exhaust pipes (Refer to 11 - EXHAUST SYSTEM/CATALYTIC CONVERTER - REMOVAL).
6. Disconnect the oil level/temperature sensor harness connector.
ZH
ENGINE - 3.2L SERVICE INFORMATION
9 - 797
7. Remove the front engine mount bolts (1).
8. Lower the vehicle.
9. Remove the engine cover (Refer to 9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL).
10. Remove the dipstick tube (Refer to 9 - ENGINE/LUBRICATION/OIL PAN - REMOVAL).
11. Install and engine support bracket.
Note: Be sure not to lift the engine to far. Damage to the coolant hoses, power steering lines, and A/C lines
could occur.
12. Raise the engine using the support bracket.
13. Raise the vehicle.
14. Remove the 24 upper oil pan bolts (1).
9 - 798
ENGINE - 3.2L SERVICE INFORMATION
ZH
15. Separate the upper oil pan from the engine block.
INSTALLATION
LOWER OIL PAN
Note: The components using sealant must be
assembled within ten minutes of sealant applica-
tion.
1. Clean the lower oil pan and the lower portion of the
upper oil pan gasket surfaces thoroughly.
2. Apply a 1.5 mm to 2.5 mm bead of Loctite 5900
sealant or equivalent to the lower oil pan sealing
surface (1) as shown.
3. Install the lower oil pan and oil pan bolts. Tighten
the lower oil pan bolts to 14 N·m (10 ft. lbs.).
ZH
ENGINE - 3.2L SERVICE INFORMATION
9 - 799
4. Position and install the transmission cooler lines
and retainers (1). Tighten the bolts to 10 N·m (7 ft.
lbs.).
5. Install and tighten the oil pan drain plug to 30 N·m
(22 ft lbs.).
6. Install the lower splash shield and screws (1).
Tighten the screws to 5 N·m (44 in. lbs.).
7. Lower the vehicle.
8. Fill the crankcase to the specified oil level.
9. Start the engine and check for leaks.
9 - 800
ENGINE - 3.2L SERVICE INFORMATION
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст