Chrysler Crossfire. Manual — part 601
(P0561) BATTERY SYSTEM VOLTAGE (CONTINUED)
3.
FUSED B(+) CIRCUIT OPEN
With the ignition on.
With the test light connected to a ground, probe the Fused B(+) circuit
at PCM C5 harness connector.
Note: The light should be bright. Compare to when connected
across the battery.
Does the test light illuminate brightly?
Yes
>> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
CONTROL
MODULE
-
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No
>> Repair the Fused B(+) circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
4.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and/or open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes
>> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No
>> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ZH
ENGINE - ELECTRICAL DIAGNOSTICS
9 - 549
(P0562) BATTERY SYSTEM LOW
9 - 550
ENGINE - ELECTRICAL DIAGNOSTICS
ZH
(P0562) BATTERY SYSTEM LOW (CONTINUED)
When Monitored and Set Condition
•
When Monitored: 180 seconds after the engine is started.
•
Set Condition: The voltage supply at the Powertrain Control Module (PCM) is less than 8 volts for at least 5
seconds.
POSSIBLE CAUSES
CHARGING SYSTEM
ENGINE CONTROL RELAY OUTPUT CIRCUIT OPEN
FUSED B(+) CIRCUIT OPEN
POWERTRAIN CONTROL MODULE
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
CHECK FOR CURRENT DTC
Turn the ignition on.
With the DRB III
T
, read PCM DTCs.
Is this DTC present?
Yes
>> For complete diagnosis of this DTC, refer to (P0561) BAT-
TERY SYSTEM VOLTAGE.
No
>> Go To 2
2.
INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using
the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes
>> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No
>> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ZH
ENGINE - ELECTRICAL DIAGNOSTICS
9 - 551
(P0563) BATTERY SYSTEM HIGH
9 - 552
ENGINE - ELECTRICAL DIAGNOSTICS
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст