Chrysler Crossfire. Manual — part 816
3. Press down on the retainer spring (5) and remove
the lock pin (2) from the shift lever (1). Remove the
shift lever (1), the washer (6) and spring (5), the
cover
(4)
and
the
boot
(3)
from
the
shift
mechanism.
4. Remove the propeller shaft. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - REMOVAL).
5. Lower the engine and transmission slightly with the support.
6. Loosen the cable lock nut (2) and press In on the
release button (3) to remove the reverse lockout
cable (1) from the bracket.
ZH
MANUAL - SERVICE INFORMATION
21 - 413
7. Remove the shift rod (2) from the ball stud.
Remove the retaining pin (1) from the shift mecha-
nism.
8. Lower and remove the shift mechanism (3) from
the vehicle.
INSTALLATION
Note: Be sure that the foam insulation remains in
position around the opening in the floor pan.
1. Position the shift mechanism (3) in the vehicle
above the transmission and install the retaining pin
(1). Connect the shift rod (2) to the ball stud.
21 - 414
MANUAL - SERVICE INFORMATION
ZH
2. Press the release button (3) and install the reverse
lockout cable (1) in the bracket. Tighten the lock
nut (2).
3. Install the propeller shaft. (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT - INSTALLATION).
4. Lower the vehicle.
5. Install the boot (3), the cover (4), the spring (5) and
washer (6) on the shift mechanism.
6. Press down on the washer (6) and install the
retaining pin (2).
7. Install the gear shift lever handle (1). (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/GEAR SHIFT
KNOB - INSTALLATION).
8. Connect the negative battery cable.
ZH
MANUAL - SERVICE INFORMATION
21 - 415
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст