Chrysler Crossfire. Manual — part 280
*CARGO LAMP INOPERATIVE (CONTINUED)
3.
MEASURE CARGO LAMP GROUND CIRCUIT RESISTANCE
Disconnect the Dome Lamp harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance from the Cargo Lamp harness connector cav-
ity 1 to the Dome Lamp harness connector cavity 1.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Dome Lamp. (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING
-
INTERIOR/COURTESY
LAMP
-
REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the open circuit between the Cargo Lamp and the
Dome Lamp.
Perform BODY VERIFICATION TEST.
ZH
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
8L - 133
*GLOVE BOX LAMP INOPERATIVE
8L - 134
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
ZH
*GLOVE BOX LAMP INOPERATIVE (CONTINUED)
POSSIBLE CAUSES
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
GROUND CIRCUIT OPEN
GLOVE BOX LAMP BULB
For a complete Interior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE GLOVE BOX LAMP BULB
Note: If any BCM DTCs are set, diagnose them first before continuing.
Note: Inspect Fuse 31 located in the Underhood Accessory Fuse Block. If the fuse is open, repair the cause
of the open fuse before continuing.
Turn the ignition off.
Remove the Glove Box Lamp Bulb and inspect for an open filament.
Is the Bulb filament open?
Yes
>> Replace the Glove Box Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR/GLOVE
BOX LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Go to 2
2.
MEASURE GLOVE BOX LAMP VOLTAGE
Disconnect the Glove Box Lamp harness connector.
Note: Check connector - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage between ground and the Glove Box Lamp har-
ness connector cavity 2.
Is the voltage above 10 volts?
Yes
>> Go to 3
No
>> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
ZH
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
8L - 135
*GLOVE BOX LAMP INOPERATIVE (CONTINUED)
3.
MEASURE GLOVE BOX LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Measure the resistance between ground and the Glove Box Lamp har-
ness connector cavity 1.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Glove Box Lamp. (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING - INTERIOR/GLOVE BOX LAMP -
REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the Glove Box Lamp ground circuit for an open.
Perform BODY VERIFICATION TEST.
8L - 136
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст