Chrysler Crossfire. Manual — part 810
18. Remove the synchronizer ring (1) and the clutch
body (2).
19. Remove the 6th gear idler gear (1) and needle
bearing (2).
20. Remove the main shaft (3) from the vise.
ZH
MANUAL - SERVICE INFORMATION
21 - 389
ASSEMBLY
1. Install the 6th gear needle bearing (2) and gear (1)
on the mainshaft (3).
2. Install the clutch body (2) and the synchronizer ring
(1).
Note: The inscription on the synchronizer body
must face upwards (towards the input end). The
drivers on the synchronizer ring must engage in
the grooves in the synchronizer body.
21 - 390
MANUAL - SERVICE INFORMATION
ZH
3. Assemble the synchronizer if it is not being
replaced. (Refer to 21 - TRANSMISSION/TRANS-
AXLE/MANUAL/SYNCHRONIZER - ASSEMBLY).
4. Press on the 5th/6th gear synchronizer assembly
(1).
Note: Snap rings that are bent or otherwise dam-
aged must be replaced.
5. Install the snap ring (1) on the mainshaft (2).
Check that it is fully seated.
ZH
MANUAL - SERVICE INFORMATION
21 - 391
6. Install the synchronizer ring (2). Be sure the drivers
on the synchronizer ring are engaged in the
grooves of the synchronizer body.
7. Oil the cylindrical bearing (2) and place it in the
input shaft (1).
8. Place the input shaft (1) on the mainshaft.
21 - 392
MANUAL - SERVICE INFORMATION
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст