Chrysler Crossfire. Manual — part 834
REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT
ZH
BODY - ELECTRICAL DIAGNOSTICS
23 - 7
REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT (CONTINUED)
When Monitored and Set Condition
•
When Monitored: Continuous.
•
Set Condition: The Body Control Module (BCM) reports a short to power, or an open circuit on the Rear
Spoiler Limit Switch Signal (Up) circuit.
POSSIBLE CAUSES
REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT SHORTED TO B(+)
OPEN REAR SPOILER LIMIT SWITCH GROUND CIRCUIT
REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT OPEN
BODY CONTROL MODULE
For a complete Rear Spoiler Circuit Diagram, (Refer to 23 - BODY - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT SHORT TO B(+)
Turn the ignition off.
Disconnect the BCM harness connector.
Disconnect the Rear Spoiler Limit Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Rear Spoiler Limit Switch Signal (Up) cir-
cuit at the Rear Spoiler Limit Switch harness connector.
Is the voltage above 1.0 volts?
Yes
>> Repair the Rear Spoiler Limit Switch Signal (Up) circuit for
a short to B(+).
Perform REAR SPOILER VERIFICATION TEST.
No
>> Go to 2
23 - 8
BODY - ELECTRICAL DIAGNOSTICS
ZH
REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT (CONTINUED)
2.
OPEN REAR SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT
Turn the ignition off.
Measure the resistance of the Rear Spoiler Limit Switch Signal (Up)
circuit from the BCM C4 harness connector to the Rear Spoiler Limit
Switch harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Go to 3
No
>> Repair the Rear Spoiler Limit Switch Signal (Up) circuit for
an open.
Perform REAR SPOILER VERIFICATION TEST.
3.
OPEN REAR SPOILER LIMIT SWITCH GROUND CIRCUIT
With the ignition off.
Measure the resistance between ground and the Rear Spoiler Limit
Switch Ground circuit at the Rear Spoiler Limit Switch harness con-
nector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
No
>> Repair the Rear Spoiler Limit Switch Ground circuit for an open.
Perform REAR SPOILER VERIFICATION TEST.
ZH
BODY - ELECTRICAL DIAGNOSTICS
23 - 9
REAR SPOILER LIMIT SWITCH SIGNAL (DOWN) CIRCUIT
23 - 10
BODY - ELECTRICAL DIAGNOSTICS
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст