Chrysler Crossfire. Manual — part 195

INSTALLATION

1. Install the starter (4).

2. Connect the starter cable and the ground cable with the nuts. Tighten the starter positive cable nut to 14 N·m (10

ft. lbs.). Tighten the starter ground cable nut (2) to 6 N·m (52 in. lbs.)

3. Install the starter positive cable protective plastic cap (3).

4. Install the starter bolts (1). Tighten to 42 N·m (31 ft. lbs.).

5. Install the right side exhaust pipe. (Refer to 11 - EXHAUST SYSTEM/CATALYTIC CONVERTER - INSTALLA-

TION).

6. Connect the right side O2 sensor.

7. Install the lower engine panel.

8. Lower the vehicle.

9. Connect the negative battery cable.

ZH

STARTING SYSTEM

8F - 47

HEATED SYSTEMS

TABLE OF CONTENTS

page

page

HEATED GLASS - ELECTRICAL DIAGNOSTICS . . . 1
HEATED GLASS - SERVICE INFORMATION . . . . . 12
HEATED MIRRORS - ELECTRICAL

DIAGNOSTICS . . . . . . . . . . . . . . . . . . . . . . . . . . 18

HEATED MIRRORS - SERVICE INFORMATION . . 25
HEATED SEATS - ELECTRICAL DIAGNOSTICS . . . 28
HEATED SEATS - SERVICE INFORMATION . . . . . 39

HEATED GLASS - ELECTRICAL DIAGNOSTICS

TABLE OF CONTENTS

page

page

HEATED GLASS - ELECTRICAL DIAGNOSTICS

DIAGNOSIS AND TESTING

REAR DEFOGGER SWITCH SENSE

CIRCUIT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

*REAR WINDOW DEFOGGER INOPERATIVE

. 6

BODY VERIFICATION TEST

. . . . . . . . . . . . . 10

SCHEMATICS AND DIAGRAMS

. . . . . . . . . . . . . 11

HEATED GLASS - ELECTRICAL DIAGNOSTICS

DIAGNOSIS AND TESTING

ZH

HEATED SYSTEMS

8G - 1

REAR DEFOGGER SWITCH SENSE CIRCUIT

8G - 2

HEATED GLASS - ELECTRICAL DIAGNOSTICS

ZH