Chrysler Crossfire. Manual — part 128
7. Install the accessory drive belt to the accessory
drive belt pulley. (Refer to 7 - COOLING/ACCES-
SORY DRIVE - OPERATION).
8. Install the air pump tube assembly (1) and install
the retaining bolts (2). (Refer to 25 - EMISSIONS
CONTROL/AIR
INJECTION/AIR
PUMP
INLET
TUBE - INSTALLATION).
ZH
ENGINE
7 - 47
9. Install the engine cover (1). Align the engine cover
retaining clips to the engine rubber mounts, and
push down firmly to connect engine cover to the
rubber mounts.
Note: To ease the installation of the engine cover,
apply a small amount of lubricant to the engine
cover rubber mounts.
10. Refill the cooling system. (Refer to 7 - COOLING/
ENGINE/COOLANT
-
STANDARD
PROCE-
DURE).
11. Connect the negative battery cable.
RADIATOR
DESCRIPTION
The Crossfire has a cross flow type radiator (4). The main radiator core is made of aluminum, and the side tanks
are made of plastic (3).
7 - 48
ENGINE
ZH
Note: Handle the radiator with care, plastic tanks while stronger than brass, are subject to damage.
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the radiator fan. (Refer to 7 - COOLING/
ENGINE/RADIATOR FAN - REMOVAL).
3. Drain the cooling system. (Refer to 7 - COOLING/
ENGINE/COOLANT - STANDARD PROCEDURE).
4. Remove the air cleaner inlet tubes.
5. Disconnect the upper radiator hose (1).
ZH
ENGINE
7 - 49
6. Disconnect the lower radiator hose (2).
7. Disconnect the coolant recovery reservoir hose (1).
8. Disconnect the transmission cooler line (3) located
on the right side of the radiator (automatic trans-
mission only). (Refer to 7 - COOLING/TRANSMIS-
SION/TRANS COOLER LINES - REMOVAL).
9. Disconnect the transmission cooler line (1) located
in the middle front of the vehicle (automatic trans-
mission only).
7 - 50
ENGINE
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст