Chrysler Crossfire. Manual — part 675
6. Connect oxygen sensor wiring harness connectors
(1).
7. Route oxygen sensor wire harness in harness
retainer.
8. Remove exhaust system support.
9. Lower the vehicle.
HEAT SHIELDS
REMOVAL
REMOVAL - FRONT HEAT SHIELD
1. Remove front exhaust section. (Refer to 11 -
EXHAUST SYSTEM/CATALYTIC CONVERTER -
REMOVAL).
2. Remove the heat shield nuts (1) and the heat
shield.
ZH
EXHAUST SYSTEM
11 - 11
REMOVAL - REAR HEAT SHIELD
1. Remove the muffler. (Refer to 11 - EXHAUST SYS-
TEM/MUFFLER - REMOVAL).
2. Remove the heat shield nuts (1) and the heat
shield.
INSTALLATION
INSTALLATION - FRONT HEAT SHIELD
1. Position the heat shield on the floor pan.
2. Install the heat shield nuts (1). Tighten the nuts to
10 N·m (89 in. lbs.).
3. Install the front exhaust section. (Refer to 11 -
EXHAUST SYSTEM/CATALYTIC CONVERTER -
INSTALLATION).
4. Start the engine and check for exhaust leaks.
11 - 12
EXHAUST SYSTEM
ZH
INSTALLATION - REAR HEAT SHIELD
1. Install the heat shield and the nuts (1). Tighten the
nuts to 10 N·m (89 in. lbs.).
2.
3. Install the muffler. (Refer to 11 - EXHAUST SYS-
TEM/MUFFLER - INSTALLATION).
MUFFLER
REMOVAL
REMOVAL
WARNING: THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THERE-
FORE, NEVER ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPE-
CIAL
CARE
SHOULD
BE
TAKEN
WHEN
WORKING
NEAR
THE
CATALYTIC
CONVERTER.
THE
TEMPERATURE OF THE CONVERTER RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE
OPERATION TIME.
1. Raise and support vehicle.
2. Remove the rear support bracket. (Convertible
only) (Refer to 13 - FRAME & BUMPERS/FRAME/
BRACKET - REMOVAL).
3. Support the rear section of the exhaust system.
4. Remove bolts (1) from the center connection
flange.
ZH
EXHAUST SYSTEM
11 - 13
5. Disconnect the ground (1) strap at the muffler.
6. Remove the pipe (1) from the exhaust hanger (2).
7. Pry the rubber exhaust hangers (1) off of the
bracket.
8. Remove the muffler with the pipe from the vehicle.
11 - 14
EXHAUST SYSTEM
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст