Chrysler Crossfire. Manual — part 62
9. Remove the upper parking brake shoe return
spring (2).
10. Remove the expanding lock (4).
11. The parking brake shoe assembly consists of the
following components:
•
(1) Adjuster.
•
(2) Upper return spring.
•
(3) Hold down spring.
•
(4) Expanding lock.
•
(5) Lower return spring.
INSTALLATION
Note: Coat all bearing and sliding surfaces on the
expanding lock with Anti-seize.
1. Install the parking brake adjuster (1).
2. Install the upper return spring (2).
3. Install the parking brake shoes by placing the
assembly over rear axle shaft flange.
4. Install the hold down spring (3) by using a pair of
needle-nose pliers (2).
ZH
BRAKES - BASE
5 - 81
5. Install the return spring by using a hooked tool or
needle-nose pliers (2).
6. Tighten the bolt (3) on the parking brake cable
equalizer. (Refer to 5 - BRAKES/PARKING BRAKE/
CABLES - INSTALLATION).
7. Install the disc brake rotors (1). (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/ROTORS
-
INSTALLATION).
5 - 82
BRAKES - BASE
ZH
8. Install the caliper assembly bolts (1). (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/DISC
BRAKE CALIPERS - INSTALLATION).
9. Install the wheel and tire assembly. (Refer to 22 -
TIRES/WHEELS - STANDARD PROCEDURE).
BRAKE FLUID LEVEL SENSOR
REMOVAL
CAUTION: Do not spill brake fluid on any painted
surfaces. Brake fluid can damage painted sur-
faces.
Note: The brake fluid level sensor cannot be
replaced by itself. You must replace the fluid res-
ervoir.
1. Disconnect the brake fluid level sensor harness
connector.
2. Remove the screw attaching the fluid reservoir to
the master cylinder.
3. Remove
the
fluid
reservoir
from
the
master
cylinder.
ZH
BRAKES - BASE
5 - 83
INSTALLATION
1. Install the fluid reservoir to the master cylinder.
2. Install the screw (1) attaching the fluid reservoir to
the master cylinder.
3. Connect the brake fluid level sensor harness con-
nector.
4. Fill the reservoir with MOPAR
T
brake fluid to the
proper level.
5. Bleed the braking system. (Refer to 5 - BRAKES/
HYDRAULIC/MECHANICAL/MASTER CYLINDER -
STANDARD PROCEDURE). and (Refer to 5 -
BRAKES - STANDARD PROCEDURE).
BRAKE PRESSURE SENSOR
REMOVAL
1. Remove the master cylinder (1). (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/MASTER
CYLINDER - REMOVAL).
5 - 84
BRAKES - BASE
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст