Chrysler Town & Country/Voyager, Dodge Caravan, Plymouth Voyager. Manual — part 304
ENGINE SPECIFICATIONS
.
2.5L ENGINE
9 - 47
ENGINE SPECIFICATIONS (CONT.)
9 - 48
2.5L ENGINE
.
TORQUE
.
2.5L ENGINE
9 - 49
3.0L ENGINE
INDEX
page
page
Accessory Drive Belt Service
. . . . . . . . . . . . . . . . 54
Auto Lash Adjuster
. . . . . . . . . . . . . . . . . . . . . . . . 59
Camshaft Service . . . . . . . . . . . . . . . . . . . . . . . . . 60
Checking Engine Oil Pressure
. . . . . . . . . . . . . . . 77
Crankshaft and Cylinder Block,Assembly Service
. 70
Cylinder Block
. . . . . . . . . . . . . . . . . . . . . . . . . . . 73
Cylinder Head
. . . . . . . . . . . . . . . . . . . . . . . . . . . 62
Cylinder Head and Camshaft Service
. . . . . . . . . . 59
Engine Assembly
. . . . . . . . . . . . . . . . . . . . . . . . . 53
Engine Lubrication System
. . . . . . . . . . . . . . . . . . 75
Engine Mounts
. . . . . . . . . . . . . . . . . . . . . . . . . . . 52
Engine Specifications
. . . . . . . . . . . . . . . . . . . . . . 79
General Information
. . . . . . . . . . . . . . . . . . . . . . . 50
Oil Filter and Bracket
. . . . . . . . . . . . . . . . . . . . . . 78
Oil Pan
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76
Oil Pump Service
. . . . . . . . . . . . . . . . . . . . . . . . . 76
Piston and Connecting Rod Assembly Service
. . . 66
Timing Belt Inspection—In Vehicle
. . . . . . . . . . . . 55
Timing Belt Service
. . . . . . . . . . . . . . . . . . . . . . . 56
Valve Service
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
GENERAL INFORMATION
ENGINE IDENTIFICATION NUMBER OR CODE
The engine identification number is located on the
rear of the cylinder block just below the cylinder head
(Fig. 1).
BLOCK: The cylinder block is a light weight design
created by reducing thickness in many parts and a
short 10 mm (3/8 inch) block skirt. High rigidity is
provided with ribs cast in the outer wall, a full length
water jacket, and a monoblock or beam type, main
bearing cap. This single unit four bearing cap is de-
signed to control vibration of the cylinder block parti-
tion walls.
CRANKSHAFT: A six throw, five weight crankshaft
is supported by four main bearings with number three
being the thrust bearing. The six separate connecting
rod throws pins reduce torque fluctuations while a
torsional vibration damper is used to control torsion
caused vibration of the crankshaft. Rubber lipped seals
are used at front and rear. The front seal is retained in
the oil pump case and the rear is retained in a
block-mounted housing.
3.0L ENGINE
9 - 50
3.0L ENGINE
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст