SsangYong Korando II (1996-2006 year). Manual — part 150
OM600 ENGINE MECHANICAL 1B3 -- 49
DAEWOO MY_2000
41. Remove the bolt(32).
42. Separate the spring and pull out the tensioning le-
ver(31).
43. Pry off the closing cover. Remove the bolt and then
remove the idle pulley.
44. Using the sliding hammer(36) and the threaded
pin(37), pull out the sliding rail pins(25, 26) and re-
move the sliding rail(24).
Sliding Hammer 116 589 20 33 00
Threaded Pin 116 589 02 34 00
1B3 -- 50 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
45. Remove the vacuum line from the vacuum pump.
46. Disconnect the vacuum pipe from thermo valve.
47. Remove the socket bolts(13) of the chain box.
T Type Socket Wrench 116 589 03 07 00
Magnetic Bar 102 589 03 40 00
48. Remove the cylinder head bolts in numerical se-
quence.
Cylinder Head Bolt Wrench 601 589 00 10 00
OM662LA
OM600 ENGINE MECHANICAL 1B3 -- 51
DAEWOO MY_2000
OM661LA
49. Remove the cylinder head(2) and gasket(3).
1B3 -- 52 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
Assembly Procedure
1. Replace the cylinder head gasket.
2. Install the cylinder head onto the crankcase.
Notice
Align the cylinder head holes with the guide pins.
3. Measure the length(L) of cylinder head bolts.
Notice
If the max. length is exceeded, replace the bolts.
Thread Dia.
Length (L)
When New
Max. Limit (L)
M10
80mm
82mm
M10
120mm
104mm
M10
115mm
117mm
OM662LA
4. Coat the head contact surface of bolts and thread
with oil and insert them as shown.
-- Cylinder head bolts arrangement
Bore
1
M10 x 80
. . . . . . . . . . . . . . . . . . . . . .
2
M10 x 102
. . . . . . . . . . . . . . . . . . . . . .
3
M10 x 115
. . . . . . . . . . . . . . . . . . . . . .
4
M 8 x 50
. . . . . . . . . . . . . . . . . . . . . .
5
M 8 x 80
. . . . . . . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст