SsangYong Korando II (1996-2006 year). Manual — part 244
SSANGYONG MY2002
4E-14 REAR BRAKES
2. Inspect the brake pad thickness.
Pad Thickness
10 mm
Max wear Limit
2 mm
Notice: If the thickness of both pads is not same,
replace both pads at the same time.
3. Inspect the disc thickness.
Pad Thickness
10.4 mm
Max wear Limit
8.5 mm
4. Inspect the disc plate’s scratch and deformation.
Brake Pad
1. Remove the cylinder mounting bolt (lower) at the
brake caliper.
2. Raise and fix the caliper assembly at the proper
position not to cause any damage in the hoses or
others.
YAD4C200
YAD4C210
3. Remove the brake pad and replace the new pad.
YAD4C220
REAR BRAKES 4E-15
SSANGYONG MY2002
4. Install the caliper cylinder assembly and tighten
the retaining bolt.
Installation Procedure
1. Install the brake lining between the backing plate
and the flange.
Installation Notice
Tightening Torque
4 - 8 N•m
(35 - 71 lb-in)
Notice: Apply a certain amount of grease on the
parking brake lining surface.
2. Install the brake disc and connect the parking
brake cable to the lever.
3. Install the caliper to the brake disc.
Installation Notice
Tightening Torque
4 - 8 N•m
(35 - 71 lb-in)
YAD4C230
YAD4C240
YAD4C250
YAD4C260
SSANGYONG MY2002
4E-16 REAR BRAKES
4. Install the brake hose.
Notice: The washer should be replaced new part.
5. Tighten the air bleeder screw.
Installation Notice
Tightening Torque
7 - 13 N•m
(62 - 115 lb-in)
6. Bleed the brake system after replacement.
YAD4C270
REAR BRAKES 4E-17
SSANGYONG MY2002
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
DRUM BRAKE ASSEMBLY
1. Remove the tires
Notice:
•
Park the vehicle on the flat ground and fix the
vehicle not to move it.
•
Position the transmission in NEUTRAL.
2. Disconnect the brake pipe from the rear brake.
Notice: Be carefully to prevent the brake fluid loss
and contamination.
3. Insert the bolt (M8) to the service hole of the brake
drum and remove the brake drum.
4. Remove the service hole plug of the axle shaft.
YAD4C290
YAD4C300
YAD4C310
5. Remove the return spring.
(1) Disconnect the upper return spring.
(2) Disconnect the lower return spring.
(3) Disconnect the lever spring.
(4) Disconnect the adjuster lever from the adjuster.
YAD4C320
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст