SsangYong Musso. Manual — part 492
MANUAL TRANSMISSION 5B-15
Removal & Installation Procedure
1. Disconnect the negative terminal from the battery.
2. Lift up the vehicle and fix it safely.
3. Remove the drain plug from the transmission housing and
drain the oil. Reinstall the drain plug.
Installation Notice
Tightening Torque
25 Nm
4. Disconnect the back-up switch connector.
5. Remove the breather hose.
6. Remove the speedometer connector and other wiring
harnesses and connectors.
5B-16 MANUAL TRANSMISSION
7. Remove the front and rear propeller shafts from the
transfercase.
Installation Notice
Tightening Torque
81 - 89 Nm
70 - 90 Nm
Front
Rear
8. Support the transmission on an suitable jack.
Unscrew the center mounting nuts and each sides
mounting bolts and remove the cross member.
Installation Notice
9. Remove the transmission mounting bolts.
Installation Notice
Tightening Torque (1)
Tightening Torque (2)
21 - 35 Nm
62 - 93 Nm
10. Move the transmission jack backward careful and
disengage the transmission input shaft from the engine.
Remove the transmission.
11. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
77 - 87 Nm
MANUAL TRANSMISSION 5B-17
UNIT REPAIR
MAJOR UNIT
Preceding Work : Removal of the transmission
Removal of the transfer case
Disassembly Procedure
1. Install the removed transmission into a fixture.
2. Remove the drain plug and drain the oil. Using a 13 mm
wrench, remove the clamp bolt and position the offset lever
in the 3-4 position of neutral.
Notice
Removal of the offset lever in a position other than 3-4 of
neutral will be difficult.
3. Using a pin punch and a hammer, remove the roll pin to
remove the shift lever from the offset lever.
4. Using a 15 mm wrench, remove the 8 bolts from the extension
housing.
5. Separate the extension housing from the case and shift
cover.
Separate the offset lever from the shift.
Notice
Do not remove the offset lever while the extension housing
is still assembled to the case.
6. Remove the offset lever from the extension housing with
the detent ball and spring.
7. Remove the roll pin from either the offset lever or extension
housing.
5B-18 MANUAL TRANSMISSION
8. Remove the counter shaft thrust race and bearing.
9. Carefully remove the oiling funnel from the end of the
counter shaft.
10. Using a 10 mm wrench, remove the 10 bolts from the shift
cover.
Notice
For assembly, note the location of the two bolts.
11. Lift up the shift cover after sliding it toward the drain plug
about 3 cm. At this time remove sealer bond.
12. Using a needle nose pliers, remove the 5-R lever clip.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст