SsangYong Musso. Manual — part 386
1B3-106 OM600 ENGINE MECHANICAL
VALVE SPRINGS (CYLINDER HEAD REMOVED)
Cylinder Head Removed
1 Valve Tappet
2 Valve Cotters
3 Spring Retainer
4 Valve Spring . . ... Check, replace if necessary
5 Cylinder Head
6 Stud Bolt . . . . . . . . . . . . . 12Nm
7 Washer
8 Nut . . . . . . . . . . . .. Replace, 25Nm
9 Exhaust Manifold
OM600 ENGINE MECHANICAL 1B3-107
Removal & Installation Procedure
1. Remove the nuts (8) uniformly and then remove the washer
(7), exhaust manifold (9) and gasket.
Installation Notice
Check the stud bolt (6) for damage and replace if necessary.
Tighten Torque
12 Nm
Tighten Torque
25 Nm
Tools Required
102 589 03 40 00 Magnetic Bar
116 589 06 63 00 Magnetic Finger
601 589 01 59 00 Assembling Board
601 589 02 59 00 Supporting Bridge
667 589 00 31 00 Press Lever
Replace the gasket and tighten the nuts (8).
2. Install the assembling board (11) to the cylinder head with 4
cylinder head blots (10).
Assembling Board 601 589 01 59 00
3. Pull out the valve tappet (1) with magnetic bar (12).
Notice
Place the valve tappets upside down (open end upward).
Magnetic Bar 102 589 03 40 00
4. Install the supporting bridge (13) on the cylinder head (5).
Supporting Bridge 601 589 02 59 00
1B3-108 OM600 ENGINE MECHANICAL
5. Using the press lever (14), press the spring retainer
downward and remove the valve cotters (2) with magnetic
finger (15).
Notice
Be careful not to damage guide bore of the valve tappet.
Press Lever 667 589 00 31 00
Magnetic Finger 116 589 06 63 00
6. Remove the spring retainer (3) and spring (4).
Installation Notice
Install the valve spring with the color coding (arrow) facing
down.
7. Check the valve spring and replace if necessary.
8. Installation should follow the removal procedure in the
reverse order.
OM600 ENGINE MECHANICAL 1B3-109
VALVE SPRINGS (CYLINDER HEAD INSTALLED)
Preceding Work : Removal of camshaft
1 Valve Tappet
2 Valve Cotters
3 Spring Retainer
4 Valve Spring . . .. Check, replace if necessary
5 Timing Chain
6 Cylinder Head
Notice
Remove the valve springs only when the piston is at TDC.
Tools Required
102 589 03 40 00 Magnetic Bar
116 589 06 63 00 Magnetic Finger
603 589 01 40 00 Holding Wheel
667 589 00 31 00 Press Lever
667 589 02 63 00 Supporting Bar
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст