SsangYong Korando III (2010 year). Manual — part 492
06-51
8510-00
Tailgate open switch
7. TAILGATE SWITCH
06-52
Tailgate open
▶
When pressing the tailgate switch for more than 0.1 second with driver door unlocked and vehicle
speed below 3 (±0.1) km/h, the tailgate open relay is turned ON for about 1 second, with
power OFF, ACC ON or IGN ON. However, it is turned ON when the vehicle speed is below 3
(±0.1) km/h, with IGN ON.
The tailgate open relay is turned OFF immediately after the driver door is locked or the vehicle speed
goes over 3 km/h with IGN ON during its operation. However, the BCM does not operate if the tailgate
open switch is pressed when the vehicle speed is above 3 km/h.
1.
2.
Tailgate open: REKES unlock (disarmed deterrent mode) → Tailgate open signal → Tailgate
open
-
Without SKM
When pressing the tailgate switch for more than 0.1 second with driver door unlocked and vehicle
speed below 3 (±0.1) km/h, the tailgate open relay is turned ON for about 1 second.
The tailgate open relay is turned OFF immediately after the driver door is locked or the vehicle speed
goes over 3 km/h during its operation.
When the tailgate switch on smart key is pressed in theft deterrent mode or with the smart key
detected by the exterior antenna, the SKM verifies the smart key and disarms the tailgate only. When
the tailgate is open and closed, the system enters into the theft deterrent mode again. If the tailgate
switch is not operated for 30 seconds, the system also does so.
The BCM checks that the verified smart key is in the luggage room 1 second after when the closed
tailgate is detected by the tailgate open switch with power OFF.
If there is a verified smart key in the luggage room when the tailgate is open and closed in theft
deterrent mode, the external buzzer sounds for 5 seconds.
When the driver press the tailgate open switch in order to look for the smart key, the BCM deactivates
lock so that the tailgate can be opened even though the driver door is locked. (maintains standby for
opening without verification)
1.
2.
3.
4.
With SKM
07-3
8310-00
1. LAMP SPECIFICATIONS
1) Exterior Lamps
2) Interior Lamps
Description
Numbers
Specification
Front room lamp
2
10W
Glove box lamp
1
5W
Center room lamp
1
10W
Luggage lamp
1
10W
Door courtesy lamp
2
5W
Description
Numbers
Specification
Headlamp
High beam
2
H1-55W
Low beam
2
H7-55W
Turn signal lamp
2
P21W
Position lamp
-
LED
Front fog light
2
H16-19W
Rear fog light
2
21W
Side repeater
-
LED
Rear combination lamp
Tail lamp
-
LED
Turn signal lamp
2
PY21W
Back-up lamp
2
W16W
Stop lamp
2
P21W
License plate lamp
2
W5W
High mounted stop lamp
-
LED
Puddle lamp
2
LED
07-4
Luminous intensity is a measure for the amount of light which passes through the unit area per
time unit. The SI unit of luminous intensity is the candela (cd), an SI base unit.
-
Luminous Intensity
▶
Luminance describes the amount of light that passes through or is emitted from a particular area,
and falls within a given solid angle. It is measured in sb or nt.
-
Luminance
▶
This indicates the amount of light reaching a given area. Measuring unit is lux (lx) and it is not
directly proportional to the brightness of the area as the reflection rate is not included.
-
Intensity of illumination
▶
The LED stands for "Light Emitting Diode" or "Luminescent Diode." LED is a semiconductor diode
that emits incoherent narrow-spectrum light when electrically biased in the forward direction of the
p-n junction, as in the common LED circuit. In short, it is an element that converts electric signals
into light signals. Yellow, blue, red and white LEDs are currently available.
The followings are the advantages of LED.
It is not glaring and doesn't have short circuit unlike the conventional lamps.
It is semi-permanent and doesn't generate heat.
Its power consumption is much lower than those of conventional bulbs.
-
-
▶ LED
Pin No.
Specification
Operating voltage
9 V to 16 V
Load
Max. 200 mA (relay load)
Operating temperature
-30℃ to 85℃
Storage temperature
-40℃ to ±120℃
Mounting location
Top center of inner side of windshield glass
2. AUTOMATIC LIGHT SENSOR SPECIFICATIONS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст