SsangYong Korando III (2010 year). Manual — part 153
03-44
Auto door unlock (crash unlock) control
▶
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition key to
"ON" position.
After the 7 seconds, the air bag signal is activated. If the air bag signal is turned ON (crash) from OFF,
BCM sends the door unlock signal for 5 seconds after 0.04 seconds.
The unlock signal is sent for the remaining of the period even when turning OFF the ignition switch
while receiving the unlock signal due to the crash.
The room lamps come ON when receiving the crash signal. (except when the front room lamp switch
is in OFF position.)
The turn signal lamps also blink when receiving the crash signal.
This function is reset when disconnecting the battery.
1.
2.
3.
4.
5.
6.
03-45
8710-01
12) Panic Alarm
Panic alarm by REKES signal
▶
When receiving the panic signal with Power OFF, ACC and IGN ON, the horn and turn signal lamps
operate for T1 with the interval of 0.5s ON/0.5s OFF.
When receiving the door lock or panic signal during the panic operation, the panic alarm stops.
(other commands are overridden)
The theft deterrent functions are as below:
- The theft deterrent alarm stops when receiving the panic alarm during its operation.
- The panic alarm stops and then the theft deterrent alarm starts its operation when occurring the
theft deterrent alarm conditions during panic alarm.
This function should be available regardless of the key status.
This function should be activated only when the ignition key is inserted (EU region).
1.
2.
3.
4.
5.
03-46
Panic alarm by SKM smart key's remote control
▶
When the BCM receives "Panic command by smart key remote control" as a BCAN signal, it
activates panic alarm by operating the horn and turn signal lamp for 30 seconds with a interval of
0.5s ON/0.5s OFF. However, the BCM used in EU region is operated when receiving the panic
command from the smart key remote control and the signal that the smart key is in the vehicle with
Power OFF, ACC and IGN ON.
The BCM stops the panic function and operates the function depending on the signal in the event of
following commands during turn signal lamp and horn operation by the "Panic command from smart
key remote control".
The panic alarm stops and then the theft deterrent alarm starts its operation when occurring the theft
deterrent alarm conditions during panic alarm.
All the functions are controlled by SKM and operated by signal from SKM.
1.
2.
3.
4.
Stops panic function activated by "Panic command from smart key remote control" through
BCAN signal
Panic function is activated when receiving other command
-
-
03-47
8710-01
Coming home lighting control
▶
The low beam keeps on for 30 seconds when the ignition switch is turned to ON from OFF position
with the headlamp ON.
Coming home lighting OFF condition
This function can be activated or deactivated with the diagnostic device. (default setting: active)
1.
2.
3.
3 minutes after all doors and tailgate are open and closed
(lighting goes off 30 seconds after without extension when the closed doors are open)
When receiving REKES and passenger door lock signals (close, open, close) twice during coming
home lighting operation
Lighting goes off during its operation when headlamp and AUTO light switch are turned to other
position than ON
Lighting goes off when ignition switch is turned to ON position
-
-
-
-
13) Headlamp
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст