SsangYong Korando III (2010 year). Manual — part 563
16-8
The front sub frame consists of 4 body bush mountings(A) and 2 engine bush mountings(B) which
reduce the vibration from the powertrain and road, and also control the torque. And the two engine bush
mountings consist of an engine mounting which supports the engine powertrain and a transmission
mounting.
The engine side and transmission side mountings are rubber mountings with brackets and insulators
while the body mounting is a rubber bush mounting which is fitted to the frame.
Installation of front sub
frame (4WD)
The installation of the front sub frame is the same for both automatic
transmission and manual transmission. For 4WD, the PTU and the
propeller shaft are installed.
Installation of front sub
frame (2WD)
The installation of the front sub frame is the same for both automatic
transmission and manual transmission.
PTU assembly
16-9
4015-01
Installation of rear sub
frame (4WD)
The installation of the rear sub frame is the same for both automatic
transmission and manual transmission. For 4WD, the E-coupling, propeller
shaft and rear axle are installed.
Installation of rear sub
frame (2WD)
The installation of the rear sub frame is the same for both automatic
transmission and manual transmission.
The rear sub frame system consists of body bush mountings and direct mountings which reduce the
vibration transmitted from the powertrain and road to the vehicle body.
For 4WD, it consists of 4 body mountings (bush mountings) and 2 axle mountings (bush mountings) and
for 2WD, it consists of 4 body mountings (direct mountings).
15-3
4190-00
1. SPECIFICATIONS
Unit
Item
Specification
Remarks
TPMS ECU
Voltage range
9 ~ 16 V
-
Active mode
50 mA
-
Coast mode
30 mA
-
Sleep mode
100 uA
-
Bit rate
500 Kbps
-
Modulation type
Amplitude modulation (AM)
-
Frequency
433.92 Mhz
-
Wheel module
Pressure measuring
range
0 ~ 6.375 bar
(0~92.43 psi)
1 bar = about 14.5 psi
Tolerance range of
measured pressure
±5% ( -40℃ ~ -10℃)
±2% ( -10℃ ~ 70℃)
±5% ( 70℃ ~ 100℃)
-
Tolerance range of
measured temperature
±5% ( -40℃ ~ -10℃)
±2% ( -10℃ ~ 70℃)
±5% ( 70℃ ~ 100℃)
-
Temperature
measuring range
-50℃ ~ 205℃
-
Battery life
Lithium battery
(about 3.0~3.2 V),
160,000 km or 10 years
It can be shortened
depending on use
condition.
Tire
Inflation pressure
32 psi
-
15-4
How to use
Torque wrench
To remove and install valve insert
To remove and install valve body
2. SPECIAL TOOL FOR TPMS SYSTEM
The following torque wrench and connecting adapter should be prepared when installing the TPMS
wheel module.
Torque wrench (0.1~5.0 Nm)
E-socket T-10
Tire valve changer
When fitting the wheel module, tighten the mounting bolt to the specified tightening torque (1.4 Nm)
to prevent the wheel module from being damaged due to excessive tightening.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст