SsangYong Korando III (2010 year). Manual — part 324
02-18
with EPS (electric power steering)
with HPS (hydraulic power steering)
1. BELT SYSTEM
The belt system is a single belt drive system which uses single belt and has components on the oil filter
housing as FEAD (Front End Accessories Drive) type.
Components
▶
HPS
EPS
1
Crankshaft pulley (DDU)
2
Auto tensioner
3
Tensioner pulley
4
Vacuum pulley
5
A/C compressor pulley
6
Alternator pulley
7
Water pump pulley
8
NO. 1 idler pulley
9
NO. 2 idler pulley
10
Power steering pump
-
02-19
0000-00
EGR cooler bypass valve
Exhaust gas goes to combustion
chamber without through EGR
cooler in engine cooled, and the
valve is closed by vacuum
pressure.
2. VACUUM PUMP
Vacuum pump generates the vacuum pressure and supplies it to EGR cooler bypass solenoid. This
pump is single vane type and displacement is 210 cc/rev. The lubrication oil is supplied through the hole
in hollow shaft.
Components
▶
Vacuum pump
Pump capacity: 210 cc/rev
Speed: 375 to 3,000 rpm
Lubrication temperature:
-40 to 155°C
Oil: 5W30
Drive type: Driven by exhaust
Camshaft solt
Brake booster
02-20
Front mounting assembly
Location: Front side of transfer axle housing and front side of
sub frame
Right mounting assembly
Location: Engine block side and body side member
Rear mounting assembly
Location: Rear side of transfer axle housing and
front side of sub frame
3. ENGINE MOUNTINGS
D20DTF engine mounting is 4-point mounting type and supports the engine and transaxle.
Front and rear mountings are rubber type and support the torque reaction. Left and right mountings
support the power train rods and torque reaction. Additionally, right mounting is hydraulic type and
supports the engine vibration.
Components
▶
Left mounting assembly
Location: Upper side of transfer axle housing and
body side member
Location
Front mounting
Location
BRKT-Right
MTG-4WD
Location
Front mounting
BRKT-Right
MTG-2WD
Front MTG MT
Front MTG AT
Location
Right MTG-4WD
Right MTG-2WD
02-21
0000-00
Intake manifold
4. INTAKE/EXHAUST SYSTEM
1) Intake Manifold
Intake manifold is installed on the cylinder head with 8 bolts. The variable swirl valve is introduced to
improve the EGR gas mixture and turbulence in combustion chamber and to decrease the exhaust gas.
2) Exhaust Manifold
Exhaust manifold is installed on the cylinder head with 10 stud bolts and nuts. EGR port is integrated in
cylinder head.
Components
▶
Exhaust manifold
Components
▶
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст