SsangYong Korando III (2010 year). Manual — part 187
06-35
8510-00
3) Cruise Control Switch
Cruise control switch
The cruise control is an automatic speed control system that maintains a desired driving speed without
using the accelerator pedal. The cruise control switch is fitted to the bottom right section of the steering
wheel. When this switch is operated, the AUTO CRUISE or ECO lamp on the instrument cluster comes
on.
The cruise control switch has a fivefold switch in it. The engine ECU can determine the current driving
condition since the resistance varies depending on the operation of the switch.
The cruise control system is operated at vehicle speed of between 38 km/h and 150 km/h. The manual
transmission is operated in the range of 3rd gear or higher.
This function can be used at the following traffic condition. (It is important to be careful for using this
function)
Cruise control (ON)
Cruise control (OFF)
Cruise control (Acceleration)
Cruise control (Deceleration)
Cruise control (Reset)
06-36
4) Horn Switch
Horn switch
Two horns are installed in the radiator grille at the bottom of both sides (one on each side). There is
another horn installed at the bottom of the battery tray side in the engine compartment for theft alarm.
Operating the horn switch on the steering wheel applies the power to the horn relay to operate both
horns (Dual horn).
The theft deterrent horn is controlled by the BCM in armed mode regardless of the horn relay operation.
06-37
8510-00
Rear seat warmer switch
Front seat warmer switch
5. SEAT WARMER SWITCH
Driver seat warmer switch
Passenger seat warmer switch
Rear LH seat warmer switch
Rear RH seat warmer switch
The front and rear seat warmer switches are designed to control (LO or HI) the seat temperature. Press
the “HI (High temperature)" or “LO (Low temperature)" on the seat warmer switch to heat the seat
and seatback. When the temperature reaches 40 ±5℃, the thermistor integrated in seat connects
and cuts the power to keep the temperature stable. There is no separate seat warmer unit to control the
heating temperature of the seat heated wire.
(STD class)
06-38
Overhead console switch
6. OVERHEAD CONSOLE SWITCH
The front room lamp is controlled by the BCM.
The front room lamp comes on when opening the driver or passenger door. (door coupled operation
switch ON)
When closing the driver or passenger door, the front room lamp comes on for 2 seconds and then
dims down for 3 seconds. (door coupled operation switch ON)
The front room lamp turns on/off depending on the operation of the front room lamp ON/OFF switch
(spot switch).
-
-
-
-
Front room lamp switch
Door coupled operation switch
Sunroof switch
Front room lamp connector
Sunroof connector
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст