SsangYong Korando III (2010 year). Manual — part 54
08-11
0000-00
09-3
0000-00
1. SPECIFICATION
Specification
HPS
EPS
Alternator
Crankshaft pulley : Alternator Pulley
1 : 2.94
Normal output (idling/2200 rpm)
70/120 A
70/140A
Regulator voltage
14.6 V
←
Brush
Length
12.5 mm
←
Wear limit
7 mm
←
Battery
Type
MF
←
Capacity
90AH
←
09-4
2. INSPECTION
1) Alternator Output Test
Item
How to check
DTC set value / Action
Output
current
B terminal
current
Rotor
coil
resistance
L terminal
voltage
Disconnect the cable connected to the B
terminal on the alternator. Connect one end
of the ammeter to the B terminal and the
other end to the cable connected to the B
terminal.
Measure the maximum output value.
(Maintain the engine speed between 2,500
and 3,000 rpm.)
(Turn the headlamp and all the electrical
switches on.)
1.
2.
Pass: If the measured current is 45 A
or higher.
Fail: If the measured current is less
than 45 A.
Check the current of the B terminal.
-
-
-
Move the gear selector lever to the
neutral position.
Maintain the engine speed at 2,500 rpm
with the vehicle unloaded.
(Turn all the electrical switches off.)
1.
2.
Open circuit: If the measured
current is 5 A or higher.
-
Disconnect the negative cable from the
battery.
Remove the B terminal and turn off the
ignition switch.
Measure the resistance between the L and F
terminals with an ohmmeter.
1.
2.
3.
Pass: If the measured resistance is
between 3 and 6 Ω.
Faulty rotor coil or slip ring: If the
measured resistance is less than
3 Ω or greater than 6 Ω.
-
-
Connect the B terminal wiring.
Measure the voltage with the engine running.
1.
2.
Specification: 12.5 V to 14.5 V
Faulty IC regulator or field coil: If
the measured voltage is 14.5 V or
higher.
-
-
Disconnect the negative battery cable.
Connect the negative cable again after connecting the ammeter.
-
-
09-5
0000-00
2) Troubleshooting for Alternator
Item
Cause
Action
Overcharged battery
Defective alternator voltage regulator
Replace
defective alternator detection wiring
Repair or replace
Discharged battery
Loose alternator drive belt
Adjust the belt tension or replace
Poor connection of related circuit or
open circuit
Retighten the loose connection or
repair open circuit
Defective alternator voltage regulator
Replace
Terminated battery
Replace
Defective ground
Repair
Charge warning lamp
does not come on when
turning on ignition switch
with engine stopped
Defective alternator voltage regulator
Replace
Open circuit in charge warning lamp,
fuse or wiring
Replace or repair the charge
warning lamp or fuse
Defective ignition switch
Replace
Defective ground of alternator circuit
Repair
Charge warning lamp
does not go off after
starting engine
Defective alternator voltage regulator
Replace
Corroded or worn battery cable
Repair or replace
Loose alternator drive belt
Adjust the belt tension or replace the
belt
Defective wiring harness
Repair or replace
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст