SsangYong Korando III (2010 year). Manual — part 37
03-11
0000-00
(3) DTC Check
If several DTCs are output simultaneously, check the electric wiring for open or short circuit.
Check the low pressure fuel system and fuel filter and confirm that there are no abnormalities. Carry
out the high pressure fuel system check.
03-12
(4) Fuel System Check Procedure
03-13
0000-00
(5) High Pressure System Pressure Test
Fuel rail pressure test
▶
Disconnect the fuel rail pressure sensor
connector and then IMV connector.
1.
Connect the pressure tester to the fuel rail
pressure sensor connector.
2.
Crank the engine 2 times for 5 seconds.
3.
Read the highest pressure value displayed
on the tester display.
If the highest pressure value is 1,050 bar or
less, refer to the section "Fuel System
Check Process".
-
-
03-14
How To Use Pressure Tester
▶
Press the "TEST" button on the tester to
check if the message "TEST?" is displayed.
If the button is pressed again at 4 seconds
after starting engine cranking, the highest
pressure is displayed on the tester.
1.
2.
The fuel rail pressure value can be checked using a diagnostic device.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст