SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 36
1D-8
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
COOLANT DRAIN AND FILL UP
Draining & Filling up Procedure
1. Loosen the cap a little and release pressure and remove
the cap.
Notice
For the risk of scalding, the cap must not be opened
unless the coolant temperature is below 90°C (194°F).
2. Loosen the radiator hose and drain the coolant.
Notice
Collect coolant by using a proper container.
3. Drain the coolant from the crankcase by inserting a hose
(dia. 14 mm) onto the drain bolt on the side of crankcase
(exhaust manifold) and by loosening the plug.
Notice
•
Just loosen the drain plug to drain the coolant and
do not remove the plug completely.
•
Collect coolant by using proper container.
4. After complete draining of the coolant, remove the hose
connector to drain plug and reinstall the drain plug.
Installation Notice
5. Tighten the radiator lower drain cock.
ON-VEHICLE SERVICE
Tightening torque
30 Nm (22 lb-ft)
REPAIR INSTRUCTIONS
1D-9
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
6. Remove the de-aeration hose clamp in the coolant pump
and remove the de-aeration hose.
7. Fill up the coolant through the coolant reservoir tank.
Notice
•
Match the anti-freeze and the water ratio to
50 : 50.
•
Supplement the coolant until the coolant overflows
to the de-aeration hose.
8. Insert the de-aeration hose and completely tighten the
clamp.
9. Check the coolant level in the coolant reservoir tank.
10. Warm up (until thermostat is opened) the engine and
recheck the coolant level in the reservoir tank and fill up
the coolant if necessary.
1D-10
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
COOLANT CONNECTION FITTING
Preceding Work: Removal of cooling fan shroud
1. Bolt (M8 X 100, 2 pieces)
. . . . . . 22.5 ~ 27.5 Nm (16.6 ~ 20.3 lb-ft)
2. Engine hanger bracket
3. Coolant outlet port
4. O-ring
5. Hose mounting clamp
6. Hose
1D-11
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Removal & Installation Procedure
1. Drain coolant from the radiator.
2. Remove the hose mounting clamp (5) and disconnect
the coolant hose (6).
3. Remove the two bolts (1), the engine hanger bracket (2)
and coolant outlet port (3).
Installation Notice
Replace the O-ring with new one.
4. Installation should follow the removal procedure in the
reverse order.
5. Fill up the coolant as specified.
6. Check the leaks in the cooling system.
Specified value
22.5 ~ 27.5 Nm
(16.6 ~ 20.3 lb-ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст