SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 86
DI02-19
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE HOUSING
DI ENG SM - 2004.9
7. Remove the camshaft bearing cap bolts so that the
tightening force can be relieved evenly.
• Intake: #1, #3, #6
• Exhaust: #7, #9, #12
* However, there is no specific removal sequence.
5. Remove the chain tensioner.
6. Hold the camshafts and remove the intake camshaft
sprocket and exhaust camshaft sprocket.
4. Mark on the intake camshaft sprocket and exhaust
camshaft sprocket for timing setting during installation.
Intake
Exhaust
DI02-20
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE HOUSING
DI ENG SM - 2004.9
• Intake: #2, #4, #5
• Exhaust: #8, #10, #11
* Do not remove the bolts at a time completely. Remove
them step by step evenly.
8. Remove the intake and exhaust camshafts from the
cylinder head.
9. Remove the finger follower and the HLA device.
Notice
Avoid contact with hot metal parts when removing
the HLA device immediately after stopping the
engine.
DI02-21
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE HOUSING
DI ENG SM - 2004.9
1. Install the HLA device and finger follower. Check the HLA
device with the diagnosis procedures before installation.
2. Place the bearing cap with the OT marks on both
camshafts facing upward.
3. Tighten the camshaft bearing cap bolts.
• Intake: #2, #4, #5
• Exhaust: #8, #10, #11
• Intake: #1, #3, #6
• Exhaust: #7, #9, #12
Installation Notice
Tightening torque
25 Nm
Installation
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4
5
6
7
8
9
10
11
12
Notice
• Put the cylinder head on the locating pins.
Notice
• Apply the sealant on the cap (#12) for the vacuum
pump when installing.
• Apply the oil on the bearing journals before
installation.
• Check the finger follower positions and align if
needed.
Intake
Exhaust
DI02-22
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE HOUSING
DI ENG SM - 2004.9
6. Install the chain tensioner.
Installation Notice
4. Install the intake and exhaust camshaft sprockets and
the timing chain.
Installation Notice
Tightening torque
25 Nm + 90° + 10°
5. Rotate the crankshaft pulley two revolutions and ensure
that the OT mark on the crankshaft pulley and the OT
mark on the camshaft pulley are aligned.
Tightening torque
80 ± 8.0 Nm
Notice
If the markings are not aligned, reinstall the cylinder
head.
•
If the sprocket bolt is stretched over 0.9 mm, replace
it with new one.
•
Always install the intake camshaft sprocket first.
•
Ensure that the markings on camshaft sprocket and
timing chain are aligned.
•
Make sure that the timing chain is securely seated
on the guide rail.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст