SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 251
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
SWITCH
RODIUS/STAVIC - 2005.07
14
2E
4. Carefully pull out the center speakers and disconnect the connectors.
5. Remove the screws and take out the front cover from the instrument panel.
6. Disconnect all switch connectors including TRIP switch connector
during removal of the front cover.
2
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
SWITCH
RODIUS/STAVIC - 2005.07
15
2E
• Disconnect the air conditioner connector.
7. Remove the center switch cover and pull out the switches from it.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
SWITCH
RODIUS/STAVIC - 2005.07
16
2E
4WD SWITCH, REAR WIPER/WASHER SWITCH
1. 4WD SWITCH
Driving Mode Change
Type
Driving mode
Requirement
Neutral (A/T), Clutch signal (M/T)
Stationary
4WD CHECK Warning Light
This warning light comes on when the
4WD system is defective.
4WD LOW indicator
This indicator blinks during mode changes
(4H
↔
4 L), then goes off after completion.
TOD
P/Time
TOD
P/Time
Part time
4H
↔
2H
↔
4L
Gear
Vehicle
speed
TOD
4H
↔
4L
4WD
HIGH
4WD HIGH indicator
This indicator blinks during mode changes
(4H
↔
4 L), then goes off after completion.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
SWITCH
RODIUS/STAVIC - 2005.07
17
2E
Connector Terminals and Circuit
Rated capacity :
wiper - DC 12V, 3.0A
washer - DC 12V, 3.8A
The rear wiper operates with a specific speed when
pressing this switch. It stops when pressing the switch
again.
The washer fluid is sprayed when pressing the switch.
And, the wiper operates when pressing the switch
over 0.6 seconds.
2. REAR WIPER/WASHER SWITCH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст