SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 113
DI05-4
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LUBRICATION SYSTEM
DI ENG SM - 2004.9
LUBRICATION DIAGRAM
1. Opening pressure of by-pass valve in oil filter: 3 ± 0.4 bar
2. To prevent instant oil shortage after stopping the engine, the return check valve is installed in oil supply line of
cylinder head.
Oil injection nozzle
REF-Roller
Camshaft bearing
Vacuum pump
Oil tensioner
check valve
Chain lubrication
Return check valve
to cylinder head
Thrust bearing
Turbo charger
Connecting rod bearing Main bearing
Clean oil gallery
Filter by-pass valve
Oil
filter
By-pass throttle
Oil cooler
Relief valve
Contaminated oil
gallery
Oil pump
Fuel tank
DI05-5
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LUBRICATION SYSTEM
DI ENG SM - 2004.9
Oil Pressure Switch
• Operating temperature: -40 ~ 140°C
• Operating pressure: 0.3 ~ 0.55 bar
• Permissible pressure: 10 bar
Engine oil
SPECIFICATIONS
Specification
Capacity
Service interval
Severe condition:
- When most trips include extended idling and/or frequent low-speed operation as in stop-and-go traffic.
- When most trips are less than 6 km (Operating when outside temperatures remain below freezing and when most
trips are less than 16 km)
- When operating in dusty, sandy and salty areas
- In hilly or moutainous terrain
- When doing frequent trailer towing
Engine oil filter
Oil relief valve opening pressure
Approved by MB Sheet 229.1 or 229.3
Viscosity: See MB Sheet 224.1
6.8 ~ 8.3 liter
Initial change: 5,000 km, Change every 10,000 km or
12 months (Frequently check the oil level and add if needed.
And, every 5,000 km or 6 months under severe conditions)
Same interval with engine oil
5.8 ± 0.3 bar
DI05-6
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LUBRICATION SYSTEM
DI ENG SM - 2004.9
Oil Pump
Differences between D27DT and old model (D29ST)
- Enlarged pump capacity: Width of tooth (pump gear): 33 mm (D29ST: 30 mm)
- Increased number of teeth (sprocket): 26 (D29ST: 24)
Oil Cooler
• Oil cooler mounting bolt: M6 x 16: 4
Engine
Oil
Relief Valve Opening Pressure
D27DT
MB SHEET
229.1/3
SAE 10W 40, 5W 40
5.8 ± 0.3 bar
Tightening torque
10 Nm
• Replace two oil cooler gaskets with new ones when the
oil cooler has been removed.
DI05-7
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LUBRICATION SYSTEM
DI ENG SM - 2004.9
Blow-by Gas Reduction Device
Cylinder Head Cover
Baffle plate assembly: The baffle plates in cylinder head cover separates oil and gas from blow-by gas, and controls the
blow-by gas speed to send only gas to separator.
to air duct
hose
Oil dipstick tube
PCV valve + oil
separator
U-type oil
drain pipe
Blow-by gas inlet port
Baffle plate
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст