SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 292
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
16
FFH & PTC
STAVIC - 2004.09
3B
Glow plug
1. Glow plug
2. Combustion chamber with flame pipe
Combustion chamber housing
1. Jacket
2. Combustion chamber
3. Combustion chamber housing
4. Insulation washer
5. Seal - combustion chamber / combustion air fan
6. Seal - combustion chamber / heat exchanger
Flame sensor
1. Flame sensor
2. Graphite bush
3. Bush
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
17
FFH & PTC
STAVIC - 2004.09
3B
Combustion air fan
1. Combustion chamber
2. O-ring
3. Rubber seal
4. Combustion air fan
5. Screw
Check flame sensor
Check the surface sensor with a digital multimeter. If the re-
sistance of flame sensor is out of specified values, the flame
sensor is defective.
Temperature [
°C]
Resistance [
Ω]
Specified value
250
1941
200
1758
150
1573
130
1498
100
1385
90
1347
80
1309
50
1194
30
1097
20
1062
10
1022
0
1000
-50
803
350
2297
300
2120
400
2470
Resistance (Ohm)
Temperature (°C)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
18
FFH & PTC
STAVIC - 2004.09
3B
Combustion chamber
1. Combustion chamber
2. Heat exchanger
3. Jacket
4. O-ring
5. Seal - combustion chamber / heat exchanger
Heat exchanger
1. Jacket
2. Heat exchanger
3. Combustion chamber with flame tube
4. Seal - combustion chamber / heat exchanger
5. O-ring (for heat exchanger)
Heat exchanger
1. Heat exchanger
2. Jacket
3. Stopper
4. Groove (bottom of heat exchanger)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
19
FFH & PTC
STAVIC - 2004.09
3B
Removal and Iinsallation of Fuel Pump
1. Disconnect Fuel Pump Connector as the vehicle lifted.
2. Disconnect both left (2) and right (3) fuel supply hose
in above picture.
3. Unscrew fuel pump mounting bolt (10M-1EA) and
disassemble fuel pump.
Fuel Pump
7. REMOVAL AND INSTALLATION
Preceding Work: Disconnection of negative battery cable
[Notice]
Cap the fuel supply hose to prevent oil leakage
Tightening torque
10 ± 1.0 Nm
•
This supplementary heater is a fuel burning type and improves the heating effect by increasing the engine coolant
temperature.
•
This device is automatically operated by conditions of the coolant temperature and the ambient temperature.
•
In initial operating stage, the fuel pump generates the operating sound and the FFH heater produces white smoke. These
are normal states to fill the fuel into the FFH fuel line.
[Notice]
Fuel Tank
FFH
3. Fuel supply hose
1. Fuel pump connector
2. Fuel supply hose (FFH)
4. Fuel pump
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст