SsangYong Rexton. Manual — part 538
AUTOMATIC TRANSMISSION 5A-23
SSANGYONG Y200
Power Flow - Reverse
In Reverse, transmission drive is via the input shaft
and the forward clutch cylinder to the hub of the C3
clutch. The elements of the transmission function as
follows;
•
The C3 clutch is engaged and drives the reverse
sun gear in a clock-wise direction.
•
The B2 band is engaged and holds the planetary
gear carrier stationary causing the long pinion to
rotate anti-clockwise about its axis on the pinion
shaft.
•
The long pinion drives the internal ring gear in the
same direction.
•
The internal ring being splined to the output shaft
drives it in an anti-clockwise or reverse direction.
Control
To maintain this arrangement in the steady state sole-
noids and valves are activated as follows;
•
Solenoids S1 and S2 are switched OFF.
•
Line pressure is directed through the reverse lockout
valve to both the inner and outer apply areas of the
rear servo piston for B2 band application.
•
Line pressure feeds the reverse oil circuit via the
manual valve.
•
Reverse oil is routed from the manual valve to the
C3 clutch.
•
Reverse oil is also applied to the spring end of the
primary regulator valve to assist the spring and to
boost the line pressure value.
•
All other clutch and band apply circuits are open to
exhaust.
KAA5A340
C3
X
Gear State
Reverse
C1
-
C2
-
C4
-
B1
-
B2
X
1-2
OWC
-
3-4
OWC
-
LU
CLUTCH
-
ELEMENTS ENGAGED
5A-24 AUTOMATIC TRANSMISSION
SSANGYONG Y200
MANUAL 1
KAA5A35A
AUTOMATIC TRANSMISSION 5A-25
SSANGYONG Y200
Power Flow - Manual 1
In Manual 1, transmission drive is via the input shaft
to the forward clutch cylinder. The elements of the
trans-mission function as follows;
•
The C2 clutch is engaged to drive the forward sun
gear, via the 3-4 OWC.
•
The B2 band is engaged to hold the planetary gear
carrier stationary.
•
The forward sun gear drives the short pinion anti-
clockwise.
•
The short pinion drives the long pinion clockwise.
•
The long pinion rotating about its axis drives the
inter-nal ring gear and the output shaft in a clockwise
or forward direction.
•
The C4 clutch provides engine braking through the
3-4 OWC on overrun.
Control
To maintain this arrangement in the steady state sole-
noids and valves are activated as follows;
•
Solenoids S1 and S2 are switched ON.
•
The 1-2, 2-3, and 3-4 shift valves are held in their
first gear positions by line 500 pressure.
•
Drive (line pressure) oil from the manual valve en-
gages the C2 clutch.
•
Lo-1st (line pressure) oil is routed through the 1-2
shift valve to the C4 clutch, and to the inner apply
area of the rear servo piston for B2 band application.
KAA5A360
ELEMENTS ENGAGED
Gear State
Manual 1
C1
-
C2
X
C3
-
C4
X
B1
-
B2
X
1-2
OWC
-
3-4
OWC
X
LU
CLUTCH
-
5A-26 AUTOMATIC TRANSMISSION
SSANGYONG Y200
DRIVE 1
KAA5A37A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст