SsangYong Rexton. Manual — part 674
SSANGYONG Y200
9D-10 BODY ELECTRICAL
YAD9D140
YAD9D150
YAD9D160
CHECK AND ADJUST
Adjust Focus of Head Lamp (Aiming)
Beam adjusting equipment approved can adjust
accurately focus of head lamp.
This equipment should be operated by manufacturer’s
operation manual.
While focus of head lamp is arranged, condition of
vehicle keep air pressure of tire specified, except spare
tire and tool of OVM, every thing is unloaded, and
vehicle is parked on the even place.
If beam adjusting is not installed, focus of head lamp
can be arranged by using screen.
Using Beam Adjusting Equipment
1. Beam adjusting equipment should be arranged
with vehicle.
2. Switch on control lever of up and down, left and
right by the screw, arrange focus of head lamp.
Arrange Focus of Head Lamp by Screen (Unit: mm)
1. After screen (2 m x 1.5 m) installs the verticalness
position of 3m of distance from the front head lamp
of vehicle, keep line of center between vehicle and
screen such as the right below picture.
BODY ELECTRICAL 9D-11
SSANGYONG Y200
;;;
;;;
;;
;;
YAD9D170
YAD9D180
YAD9D150
2. Keep line of center between through horizontal line
of center of head lamp and center of screen.
3. Keep engine R.P.M of 2000, and then switch head
lamp on, at this time focus of head lamp should
indicate position of “A” .
4. If focus of head lamp get out of specification, after
switching control lever of up and down, left and
right, arrange focus of head lamp.
SSANGYONG Y200
9D-12 BODY ELECTRICAL
YAD9D190
BODY ELECTRICAL 9D-13
SSANGYONG Y200
REPAIR OF EACH SYSTEM
INSTRUMENT PANEL ASSEMBLY
YAD9D200
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст