SsangYong Rexton. Manual — part 442
SSANGYONG Y200
1F2-94 M161 ENGINE CONTROLS
PURGE CONTROL VALVE
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the purge control valve connector.
3. Disconnect the throttle body-to-purge control valve
hose from the purge control valve.
4. Disconnect the canister-to-purge control valve
hose from the purge control valve.
5. Remove the purge control valve.
6. Installation should follow the removal provedure
in the reverse order.
YAA1F800
YAD1F670
YAA1F810
3. Remove the canister mounting bolts.
Installation Notice
CAMSHAFT POSITION SENSOR
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the cam-
shaft position sensor.
3. Remove the camshaft position sensor retaining
bolt.
Installation Notice
YAD1F660
CANISTER
Removal and Installation Procedure
Caution: Canister and vacuum hoses contain fuel
vapors. Do not smoke in the area or permit an open
flame.
1. Disconnect the fuel tank-to-canister hose form the
canister.
2. Disconnect the canister-to-purge control valve
hose form the canister.
Tightening Torque
6 N•m (53 lb-in)
4. Remove the canister.
5. Installation should follow the removal procedure
in the reverse order.
Tightening Torque
10 N•m (89 lb-in)
M161 ENGINE CONTROLS 1F2-95
SSANGYONG Y200
4. Check the O-ring for damage and replace it if
necessary.
5. Installation should follow the removal procedure
in the reverse order.
KAA1F200
ENGINE CONTROL MODULE
Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Remove the cowl side trim form passenger side.
Re-er to Section 9G, Interior trim.
3. Remove the four securing nuts for the Engine
Control Module (ECM) from the mounting bracket.
Installation Notice
KAA1F160
CRANKSHAFT POSITION SENSOR
Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector at the crankshaft
position sensor.
3. Remove the crankshaft position sensor retaining bolt.
Installation Notice
Tightening Torque
10 N•m (89 lb-in)
4. Installation should follow the removal procedure
in the reverse order.
Tightening Torque
10 N•m (89 lb-in)
4. Pull out the ECM from the bracket.
5. Disconnect the vehicle side coupling.
6. Installation should follow the removal procedure
in the reverse order.
SSANGYONG Y200
1F2-96 M161 ENGINE CONTROLS
ECM WIRING DIAGRAM (2.3L DOHC - 1 OF 7) (MSE 3.53D)
SCHEMATIC AND ROUTING DIAGRAMS
YAD1F010
M161 ENGINE CONTROLS 1F2-97
SSANGYONG Y200
ECM WIRING DIAGRAM (2.3L DOHC - 2 OF 7) (MSE 3.53D)
Y
AD1F0A0
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст