SsangYong Rexton. Manual — part 641
SSANGYONG Y200
7D-30 AUTOMATIC CONTROL HVAC SYSTEM
4. Installation should follow the removal procedure
in the reverse order.
Notice: Insert the connectors to the switch and
then assemble the control switch completely.
BLOWER MOTOR
1. Remove the glove box and put the floor mat aside.
2. Disconnect the connectors connecting the blower
motor.
3. Remove four bolts securing the blower motor and
remove the motor assembly.
4. Installation should follow the removal procedure
in the reverse order.
YAD7D190
YAD7D200
YAD7D210
YAD7D220
AUTOMATIC CONTROL HVAC SYSTEM 7D-31
SSANGYONG Y200
HIGH BLOWER RELAY
1. Remove the high relay connector of the blower
motor.
2. Remove the bolt securing the high relay.
3. Installation should follow the removal procedure
in the reverse order.
BLOWER MOTOR RESISTANCE
(POWER TRANSISTOR)
1. Remove the connector of the power transistor.
2. Remove two bolts securing the power transistor.
3. Remove the power transistor assembly.
AIR MIX DOOR ACTUATOR
1. Disconnect the negative battery cable.
2. Remove the glove box.
3. Disconnect the connectors of the air mix door
actuator.
4. Remove three screws securing the mode control
door actuator and heater/air distributor case.
5. Remove the mode control actuator slowly and then
remove the air mix door actuator.
6. Installation should follow the removal procedure
in the reverse order.
4. Installation should follow the removal procedure
in the reverse order.
YAD7D230
YAD7D240
YAD7D250
SSANGYONG Y200
7D-32 AUTOMATIC CONTROL HVAC SYSTEM
MODE CONTROL DOOR
ACTUATOR
1. Disconnect the negative battery cable.
2. Remove the driver’s knee bolster or lower cover.
3. Disconnect the connector to mode control door
actuator.
4. Remove three screws securing the mode control
door actuator and heater/air distributor case.
5. Remove the mode control actuator slowly and then
remove the mode control door actuator.
6. Installation should follow the removal procedure
in the reverse order.
SUN SENSOR
1. Remove the sun sensor from the instrument panel.
2. Disconnect the sensor connector and remove the
sun sensor.
3. Installation should follow the removal procedure
in the reverse order.
Notice: For disconnecting the connector from the
sun sensor, be careful that the wiring must not
come into the instrument panel.
INSIDE AIR TEMPERATURE
SENSOR
1. Remove the instrument panel.
2. Disconnect the sensor connector, remove the
inside air temperature sensor with the tube.
YAD7D260
YAD7D270
YAD7D280
YAD7D290
AUTOMATIC CONTROL HVAC SYSTEM 7D-33
SSANGYONG Y200
3. Remove the inside air temperature sensor sub from
the instrument panel.
4. Installation should follow the removal procedure
in the reverse order.
AMBIENT AIR TEMPERATURE
SENSOR
1. Remove the left headlamp assembly.
2. Disconnect the ambient air temperature sensor at
the clip hole of the headlamp support outer panel
and then disconnect the connector.
YAD7D300
YAD7D310
YAD7D320
YAD7D330
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст