SsangYong Rexton. Manual — part 363
SSANGYONG Y200
1B3-28 DIESEL ENGINE MECHANICAL
1st Step
2nd Step
3rd Step
Cylinder Head Bolt Tightening Torque
YAD1BBE0
Tightening Sequence for Cylinder Head
Bolts
Notice: The cylinder head may only be removed when
the engine has cooled down. The cylinder head is
removed together with the exhaust manifold. As the
cylinder head bolts undergo a permanent tightening.
They require to be replaced if they exceed the
maximum lengthes indicated in the table.
The twelve-sided socket head bolts are tightened with
each stages of torque and torque angle.
It is not necessary to retighten the cylinder head bolts
at the 1000~1500 km inspection or after 1000~1500
km of repairs.
YAD1BBD0
Length(L) When New
80 mm
102 mm
115 mm
Thread Dia.
M10
M10
M10
Max. Length(L)
82 mm
104 mm
117 mm
Cylinder Head Bolts (12-sided socket head)
(Engine cold)
M8 Cylinder Head Bolts
10 N•m (89 lb-in)
35 N•m (26 lb-ft)
180°
25 N•m (18 lb-ft)
DIESEL ENGINE MECHANICAL 1B3-29
SSANGYONG Y200
YAD1BBF0
YAD1BBG0
YAD1BB30
Tools Required
116 589 02 34 00
Threaded Pin
116 589 03 07 00
T Type Socket Wrench
116 589 20 33 00
Sliding Hammer
602 589 00 40 00
Engine Lock
603 589 00 40 00
Counter Holder
Removal Procedure
1. Completely drain the coolant from the radiator and
cylinder block.
2. Remove the cooling fan shroud.
3. Hold the fan with counter holder 603 589 00 40 00
and remove the bolt and then remove the cooling
fan.
4. Remove the bracket oil dipstick tube.
5. Remove the tensioning lever nut.
6. Remove the nut on the tensioning lever and insert
the rod(
φ
18, 180 mm). By pushing the rod to the
arrow direction, pull back the bolt.
SSANGYONG Y200
1B3-30 DIESEL ENGINE MECHANICAL
YAD1BB40
YAD1BBH0
YAD1BBJ0
YAD1BBK0
7. Push the tensioning lever to the opposite direction
to release the spring tension and remove the poly
V-belt.
8. Unscrew the EGR pipe mounting bolts onto the
exhaust manifold.
9. Remove the duct bracket from the cylinder head.
10. Unscrew the intake duct mounting bolts onto the
intake manifold.
11. Separate the connecting rod from the control lever.
DIESEL ENGINE MECHANICAL 1B3-31
SSANGYONG Y200
YAD1BBL0
YAD1BBM0
YAD1BBN0
YAD1BBP0
13. Remove the fuel injection line (1) from the fuel
injection nozzle (12).
14. Remove the fuel injection line from the fuel injection
pump.
15. Remove the bracket mounting bolts and then
remove the fuel injection line (1).
12. Pull out the accelerator control linkage.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст