SsangYong Rexton. Manual — part 321
M162 ENGINE MECHANICAL 1B1-87
SSANGYONG Y200
YAD1B2G0
17. Rivet the link pin.
Check the condition and it again if necessary.
18. Install the chain tensioner.
Installation Notice
19. Check the camshaft timing position.
Screw Plug
Tensioner
Assembly
Tightening
Torque
40 N•m (30 lb-ft)
72 - 88 N•m
(53 - 65 lb-ft)
SSANGYONG Y200
1B1-88 M162 ENGINE MECHANICAL
TENSIONING RAIL
Preceding Work : Removal of timing gear case cover
1 Tensioning Rail
2 Plastic Guide
Removal & Installation Procedure
1. Put the assembly mark at the camshaft sprocket
and the timing chain with the paint (arrow).
2. Remove the exhaust camshaft sprocket.
3. Remove the tensioning rail (1) from the tensioning
rail pin (3).
Notice:
•
Replace the plastic guide (2) if it is damaged.
•
For installation, exactly align the plastic guide
(2) with the tensioning rail (1).
4. Installation should follow the removal procedure
in the reverse order.
5. Check the camshaft timing position.
YAD1B2H0
3 Tensioning Rail Pin
4 Guide Rail
M162 ENGINE MECHANICAL 1B1-89
SSANGYONG Y200
YAD1B2J0
CYLINDER HEAD GUIDE RAIL
Preceding Work : Removal of cylinder head cover
Removal & Installation Procedure
1. Remove the chain tensioner (1).
2. Turn the exhaust camshaft to the camshaft rotating
direction using the wrench (4) and loosen the
timing chain at upper guide rail (2).
3. Pull out the upper guide rail pin from the guide
rail (2).
4. Turn the exhaust camshaft to the opposite direction
of rotation using the wrench.
5. Check for damages at the upper sliding rail and
replace it if necessary. Install the upper guide rail
pin.
6. Install the chain tensioner.
Installation Notice
1 Chain Tensioner
2 Upper Guide Rail
3 Upper Guide Rail Pin
4 Wrench (Special Tool)
Screw Plug
Tensioner
Assembly
Tightening
Torque
40 N•m (30 lb-ft)
72 - 88 N•m
(53 - 65 lb-ft)
SSANGYONG Y200
1B1-90 M162 ENGINE MECHANICAL
YAD1B2K0
CRANKCASE GUIDE RAIL
Preceding Work : Removal of timing gear case cover
1 Guide Rail
2 Plastic Guide
Removal & Installation Procedure
1. Put the assembly mark at the camshaft sprocket
and the timing chain with the paint (arrow).
2. Remove the exhaust camshaft sprocket.
3. Remove the guide rail (1) from the guide rail pin
(3).
Notice:
•
Replace the plastic guide (2) if damaged.
•
Connect the plastic guide (2) and the guide rail
(1) by aligning them accurately when installing.
4. Installation should follow the removal procedure
in the reverse order.
5. Check the camshaft timing position.
3 Guide Rail Pin
4 Tensioning Rail
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст