SsangYong Rexton. Manual — part 613
POWER STEERING 6A-11
SSANGYONG Y200
YAD6A140
Steering Effort Check
1. Place a vehicle on the paved flat ground with front
wheels In a straight ahead position.
2. Start the engine and run it at 1,000 rpm.
3. Using a scale, measure the steering effort in both
directions.
Notice: The difference in steering effort of left/
right should be within 0.6 kg.
Standard
Max. 3.0 kg
SSANGYONG Y200
6A-12 POWER STEERING
1
2
ON-VEHICLE SERVICE
POWER STEERING PIPE/HOSE
Removal
1. Remove the supply pipe (1) and return hose (2)
which is installed in power steering pump.
Notice: When removing/installing the pipe and
hose, prepare the oil container in order that the oil
may not drop down.
YAD6A160
YAD6A170
2. Remove the supply/return pipe installed in power
steering gear box.
3. Remove the oil pipe bracket bolt installed in front
bumper and pull off the oil pipe.
Notice: First, remove the pipe from the pipe clamp
installed in front panel and then pull off the pipe.
YAD6A180
MAINTENANCE AND REPAIR
POWER STEERING 6A-13
SSANGYONG Y200
POWER STEERING GEAR BOX
ASSEMBLY
1. Remove the tie rod installed in steering knuckle.
Disassembly the split pin and sloted nut in tie rod
end and pull off the tie rod using the special tool.
YAD6A190
YAD6A200
YAD6A220
YAD6A210
2. Remove the joint blot of steering lower shaft and
separate the lower shaft from the gear box.
3. Remove the center bolt in gear box and left
mounting bolt. Remove the supply/return pipe
connection bolt.
4. Remove the clamping bolt and pull off the steering
gear box assembly.
SSANGYONG Y200
6A-14 POWER STEERING
STEERING GEAR PUMP
1. Separate the drive belt from pump pulley after each
pipe and hose is removed.
YAD6A230
YAD6A250
YAD6A260
ASSEMBLY INSTALLATION
1. Install the power steering pump in engine and
tighten the bolt/nut as specified torque.
Torque
23 N•m (17 lb-ft)
23 N•m (17 lb-ft)
Nut
Bolt
Upper
Lower
2. Install the power steering gear box in frame.
Tighten the mounting bolts slightly and then install
the gear box clamp in left. Tighten the bolt/nut as
specified torque.
Notice: Because the length of bolt is same, install
them after checking.
Installation Notice
70 - 90 N•m
(52 - 66 lb-ft)
70 - 90 N•m
(52 - 66 lb-in)
95 mm Bolt/Nut (Upper)
95 mm Bolt/Nut (Lower)
YAD6A240
2. Remove the bolts/nuts in pump and pull off the
pump assembly from engine.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст