SsangYong Rexton. Manual — part 681
SSANGYONG Y200
9D-38 BODY ELECTRICAL
YAD9D750
YAD9D760
YAD9D770
2. After releasing the housing fixing screw of lamp,
and then separate housing.
3. After separating connector of lamp housing,
remove lamp housing.
4. Install the reverse order of removal.
2. After releasing housing fixing screw of lamp,
separate the housing.
3. After removing connector from the lamp housing,
remove lamp housing.
4. Install the reverse order of removal.
Center / rear lamp
1. After removing lense of lamp, remove bulb.
BODY ELECTRICAL 9D-39
SSANGYONG Y200
HORN AND AUDIO SYSTEM
General Description
Horn
Horn is located under the hood, is also installed near
radiator in the front. Horn is operated by pushing pad
of steering wheel which is linking to the electric circuit.
Audio system
Audio
Radio and cassette are installed in the audio system
by standard specification, changer of cd is applied
option specification, which is installed on the room of
trunk.
Front and rear speaker
Eight of speaker is installed in the vehicle, two of
speaker is installed on the front door, rear door, and
tail gate and an speaker is installed each side mirror
(left, right).
Glass antenna
Glass antenna is different from existing antenna, is
not appeared external shape of antenna,this one is
installed on the quarter glass, consists of module of
glass antenna, harness, and connector. The sensitivity
of reception are better than the existing antenna.
YAD9D780
SSANGYONG Y200
9D-40 BODY ELECTRICAL
YAD9D790
YAD9D800
YAD9D810
YAD9D820
Removal and Installation
Horn
1. After releasing fixing bolt, remove horn.
2. Install the reverse order of removal.
2. Remove speaker of tail gate.
1) Remove trim of tail gate and seal.
2) After releasing fixing screw and connector of
speaker, remove speaker.
3) Install the reverse order of removal.
Speaker
1. Remove front door speaker and rear.
1) Remove door trim and seal.
2) After separating connector of speaker, and then
release fixing screw of speaker.
3) Remove speaker.
4) Install the reverse order of removal.
3. Adjust
•
After operating the horn, and then adjust tone
of horn proper (adjust screw of controlling).
Notice: After adjusting screw, spread paint on the
screw of adjusting, do not release screw of
adjusting.
BODY ELECTRICAL 9D-41
SSANGYONG Y200
YAD9D830
YAD9D840
YAD9D850
YAD9D860
3. Remove speaker of side.
1) Remove door trim.
2) After removing speaker assembly, remove
connector of speaker.
3) Install the reverse order of removal.
Controller of audio remote
1. Remove air bag module of steering wheel or horn
pad on the driver seat.
2. After releasing connector and fixing screw, and
then remove remote control.
3. Install the reverse order of removal.
3. Remove audio
•
Release fixing screw of audio.
•
Separate cable of antenna and connector.
•
Remove audio.
4. Install the reverse order of removal.
Accessory of audio system
Audio
1. Separate the negative terminal of battery.
2. Remove center of instrument panel.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст