SsangYong Actyon Sports II. Manual — part 99
04-10
No.
Symbol
Item
24
Engine oil pressure
warning lamp
25
Water separator
warning light
26
Engine coolant
overheat warning light
27
Engine hood open
warning lamp
28
EBD warning light
29
SSPS warning lamp
30
Hazard warning lamp
Power
Turning ON condition
IGN
Signal input
IGN
IGN ON/ CAN signal input
IGN
IGN ON/ CAN signal input
IGN
Switch ground
IGN
CAN signal input
IGN
Digital input
IGN
Switch to High
04-11
8210-01
2. CONFIGURATION
1) RPM Gauge
The tachometer indicates engine speed in revolutions per minute. Multiply 1,000 to the current number,
then it will be the current number of engine revolutions.
Under the normal engine operating temperature, the proper idling speed is 700 ~ 800 rpm. The red zone
(danger rpm range) starts from 4,500 rpm.
Connect the tachometer for tune-up test and start the engine.
Eliminate the hysteresis by tapping the tachometer.
Compare the values on the tester and tachometer and replace the tachometer if the tolerance is
excessive.
1.
2.
3.
If the tachometer (engine rpm gauge) pointer vibrates or stops moving at a certain range, or abnormal
noises are heard from the tachometer, the tachometer may have a malfunction. If you have reason to
suspect that the reading from the tachometer differs from the actual engine speed (rpm), connect a
diagnostic device and compare the value on tachometer with the reading from the diagnostic device.
Check Method
04-12
2) Speedometer Gauge
The speedometer indicates the vehicle speed by calculating the signals from the rear left and rear right
wheel speed sensors through ABS or ESP unit. (For the vehicle without ABS or ESP, the signals are
received from the EMS)
If the speedometer gauge vibrates, stops at a certain range or makes an abnormal noise, there could be
defectives in speedometer. However, these symptoms also could be occured when the tire has
uneven wear, different tire inflation pressures or different tire specifications.
Perform the speedometer test regarding the tolerance as described. However, it is not similar simple
work in field due to lack of measuring conditions such as test equipment and preciseness.
Check the allowable tolerance of the speedometer and operations of the trip odometer by using
a tester.
Check if the speedometer pointer is shaking and the abnormal noise sounds.
Eliminate the hysteresis by tapping the speedometer.
1.
2.
3.
04-13
8210-01
The allowable tolerance increases when the tires are worn or the tire pressure is out of specified
range.
Speed Input from ESP(ABS) or MS(ECU)
▶
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст