SsangYong Actyon Sports II. Manual — part 107
07-11
7810-01
When the washer switch is turned on for more than 0.6 seconds during the wiper operation by
INT switch, the operation in step (2) is performed.
When it is turned on for a certain period of time (0.1 to 0.59 seconds), the operation in step (1) is
performed.
3.
4.
07-12
3. CIRCUIT DIAGRAM
08-3
8610-09
Multifunction Wiper Switch:
AUTO and Sensitivity Control
1. OVERVIEW
The rain sensing wiper unit system doesn't control the wiper directly. The rain sensing unit detects the
amount of rain drops and sends the operating signal to STICS, and STICS drives the wiper directly.
Rain Sensing Unit
(AUTO Light Sensor Integrated Type)
A sensor that emits infrared rays through LED
and then detects the amount of rain drops by
receiving reflected rays against sensing section
(rain sensor mounting section on the windshield)
with photodiode. The auto light sensor is
Integrated into the rain sensor (refer to the below
picture).
AUTO: Wiper operates automatically by rain
sensor
FAST SLOW: Auto delay/auto speed
control. A position that can control sensitivity
against rains on the windshield and transmits
wiping demand signal accordingly.
Emitter lens
The LED which is located at
bottom emits the infrared rays and
the lens guides the infrared rays to
target point.
Auto light sensor
Enlarged auto light
sensor section
Auto light sensor(Vertical)
Auto light sensor (Horizon)
08-4
STICS
Engine Compartment Fuse Box
STICS
▶
The rain sensing unit detects the amount of rain drops and sends the operating signal to STICS, and
STICS drives the wiper directly. At this moment, STICS determines the wiper operation mode (washer,
MIST, AUTO), then sends the information to the rain sensor.
Auto Light Sensor and Rain Sensor Coupled Control
▶
Rain detected headlamp: If it rains heavy which requires the highest INT speed (almost LOW),
the headlamps are turned on automatically.
-
Night detected wiping: When the auto light control turns on the headlamps and the rain sensor
detects the rain, the wiper sensitivity is automatically increased by one level in comparison with
daytime.
(i.e. the AUTO wiper switch is at the 3rd level, but the wiper operates at the 4th level.)
-
Wiper relay (HI)
Wiper relay (LO)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст